[Setup] initial setting screen
[Power] (power ON) setting
Whether the system is to be started from the [Reset] status,R1R2R3R4R5
from the [Preset] status or in the [Demo] mode can bePower
selected using the rotary 2 control.Reset
With [Reset], the settings except for the event memories,Reset
setup settings, file memory and key learn settings arePreset
initialized.Demo
With [Preset], the mode in which the system is started from
the status prior to power OFF is established when the power
is next turned on.
If no status prior to power OFF existed (when, for instance, the system is used for the very first time after assembly or its
memories have been destroyed), the system is started from the factory setting status.
With [Demo], the system starts up in the demonstration mode when the power is next turned on. This menu is displayed in
the demonstration mode so that when the system is restarted by selecting [Preset] or [Reset], the regular operation screen
will appear. Alternatively, when [Enter] is pressed, the demonstration mode is suspended and operation is enabled. To
execute the demonstration mode again, turn the power off and then back on again. The audio faders can be used even in
the demonstration mode.
The default setting is [Preset].
[Direct Pattern] setting
This is used to set the pattern which is to be called as theR1R2R3R4R5
direct pattern.Direct
When [Setup] is selected using the rotary 2 control andPatternSetup
[Enter] is pressed, [OK?] appears so press [Enter] to change
Setup
to the setting mode. Use [Shift] + [Enter] to cancel.Default
When [Default] is selected using the rotary 2 control and
[Enter] is pressed, [OK?] appears so press [Enter] to change
to the default setting. Use [Shift] + [Enter] to cancel.
Setting method in the setting mode
[ME] is selected for Preview so it can be used to check.
1. Press the direct pattern button.
2. The lamp of the selected button flashes. The [Mix], [Chrm] (chroma) key and [Lum] (luminance) key cannot be set.
3. Use the number keys to input the pattern to be assigned. (The pattern is displayed in the pattern area.) The program
output can be checked using the wipe lever.
52 |
ACEC
