Switches
Setting the board switch positions
SW2
8
7
6
5
4
3
2
1
ONOFF
BS DIGITAL board
SW2-1: Y/G, PB/B, PR/R selector switchSW2-6: Color bar setting selector switch
ON: Y, PB, PR outputON: SNG color bar
OFF:G, B, R outputOFF:SMPTE/FULL color bar
<Note>
When selecting the positions of the above switches, make sure that you do not change the positions of the other switches indicated
with the broken lines by touching them by mistake.
Setting the microswitch position
The front cover must be removed in order to select the dynamic
microphone or carbon microphone setting.DynamicCarbon
Refer to the diagram below to perform the selection.microphonemicrophone
<Note>
The unit was shipped from the factory with the dynamic microphone
selected for this setting.
Switching the controller
Select the front panel or controller connected to the OP3 connector for
the controller. Refer to the figure at the bottom right when making this
selection.PUSH
<Note>
Turn off the unitOs power before making the selection.
CAUTIONS:
These servicing instructions are for use by qualifiedRCOP
RCOP
service personnel only. To reduce the risk of electric
CONT
shock do not perform any servicing other than that
contained in the operating instructions unless you are
ONTFR
qualified to do so.Front panel
- 18 - |
ACEC
