Checking the edit points
1Press the IN (or OUT) button to check the edit point.
The value of the entered edit point appears on the display.
2Press the PREROLL button while holding down the IN (or OUT) button to check the
image at the edit point.
The tape is cued at the edit IN (or OUT) point, and the still picture mode at that point is
displayed.
Y The EE mode is established if the TAPE/EE switch has been set to the OEE� position
when OSTOP� has been selected for the setup menu No. 313 (AFTER CUE-UP).
3Press and hold down the IN and OUT buttons together to check the edit duration.
The duration time appears on the display.
Calculating the duration
Y When both edit points have been set, the duration between the two edit points.
Y When only one edit point has been set, the duration between the set data and the current
tape address.
Y When neither edit point has been set, the duration of the previously edited interval.
INPUT SELECTEJECT
ONVIDEOY PB PRCMPSTSDTI(V&A)SDI
AUDIO ANALOGAES/EBUUSER SETSDI
AUTO OFF
OFF
POWER
CH CONDITION
TC MODECONTROL
TCINTTAPEREMOTEPUSH
JOGSHTL
METERTC/CTL
FULL/FINESLOW
UBEXTEELOCALREVFWD
LSTAND BYPLAYERRECORDER
MONITOR SELECTTC SET
RSHIFTADJ STARTRESET
WDVSCH CF
SERVOREC INHIBIT
LEVELCH1CH2CUEVIDEOVIDEO CH1CH2CUETCEDITPLAYREC
RECASSEMBLEINSERT-
PREVIEW AUTO EDITAA
HEADPHONESREVIEWPREROLLIN�+TRIMREWSTOPFFOUT
PB
INSETOUT
PULLPULL
OPENPULL FOR VARIABLEOPEN
2 1, 3
� 35 � |
ACEC
