USER menu
<AUDIO> (continued)
ItemSetting
SuperimposedSuperimposedDescription
No.No.
displaydisplay
713 MONI CH 0000MANUThis selects the monitor output.
SEL0001AUTO10: The output is as selected in MONITOR SELECT.
0002AUTO21: The output defaults to CUE except when speed factor is
between �0.43´ and 1´, inclusive, in which case output is
PCM AUDIO.
2: The output defaults to CUE except in PLAY mode, in which
case output is PCM AUDIO.
<Note>
These menu settings are valid when CH1 or CH2 has been
selected by the MONITOR SELECT L/R switches on the front
panel. (When CUE has been selected, the CUE signal will be
output at all speeds regardless of the above menu setting.)
714 REC CH10000CH1This selects the input signal to be recorded on the audio CH1
0001CH2track.
0002CH1+20: Audio input CH1 signal.
1: Audio input CH2 signal.
2: Mixed audio input CH1 and CH2 signal.
715 REC CH20000CH1This selects the input signal to be recorded on the audio CH2
0001CH2track.
0002CH1+20: Audio input CH1 signal.
1: Audio input CH2 signal.
2: Mixed audio input CH1 and CH2 signal.
716 REC CUE0000CUEThis selects the input signal recorded in CUE.
0001CH10: CUE input
0002CH21: The signal selected in Setup Menu No. 714 is recorded.
2: The signal selected in Setup Menu No. 715 is recorded.
0003CH1+2
3: A mixed signal of the signals selected in Setup Menu No.
714 and Setup Menu No. 715 is recorded.
718 DV0000ST1This selects the AUDIO CH1 and CH2 output signals during
OUTPUT0001ST2DV or DVCAM format playback.
0002ST1+20: The CH1 track signals are output to CH1 and the CH2 track
signals to CH2.
1: The CH3 track signals are output to CH1 and the CH4 track
signals to CH2.
2: The mixed CH1 and CH3 track signals are output to CH1
and the mixed CH2 and CH4 track signals to CH2.
<Note>
This item setting is valid only when the tape recorded on the
four channels of the DV or DVCAM format is played back.
719 PB FADE0000AUT OThis selects the processing method for the audio edit points
0001CUT(IN point, OUT point) during playback.
0002FADE0: According to the status during recording.
1: Forced CUT
2: Forced FADE
720 EMBEDDED 0000OFFThis selects whether to superimpose the audio data onto the
AUD0001ONserial output.
0: Data is not superimposed.
1: Data is superimposed.
<Note>
This item is valid when the optional serial interface board has
been installed.
722 INT SG0000OFFThis selects whether to use the internal signals as the audio
0001ONinput signals.
0: The internal signals are not selected.
1: The internal signals are selected.
<Note>
The internal signals have a frequency of 1 kHz.
The underline on the setting item denotes the initial setting.
� 73 �
ACEC
