Operations
OWhen PB has been selected as the setup menu
Recording
item No.105 setting, it will take two to three
seconds for recording to commence after the REC
1Use the setup menu item No.007 to selectand PLAY buttons have been pressed. (See page
recording in either the 50 Mbps mode or 2530)
Mbps mode. Set this menu item to REC to start the recording
(See page 29)faster. However, with REC set for this item, it takes
longer for the image to appear during playback after
the PLAY button is pressed.
Set the accidental erasure prevention tab on
2
the cassette to the Orecording enable�
position, and insert the tape.
3Press the STOP button to set the unit to the
Pause/recording
stop mode.
(with back-space assemble recording)
41. Selecting the input video and audio signals
1) Connect the signals that are to be
Press the PAUSE/STILL button while the
recorded.1
cassette tape is being played.
2) Select the video and audio input signals
using the INPUT SELECT button on the
front panel.Press the REC button to set the unit to the
2
REC PAUSE mode.
2. Adjusting the audio levels
Adjust the audio input signal levels.The monitor screen display now switches to theO
The audio signals are recorded at theE-E picture.
If the setup menu item No. 110 OAUTO BACK� is
appropriate level when the audio recording
set to OREC-P� or OALL,� the tape is rewound two
level controls are in the pushed-in position.
to three seconds from the position at which the
PAUSE/STILL button was pressed.
5(See page 31.)Press the PLAY button while holding down
the REC button.
The REC and PLAY lamps light, and recording
Press the PAUSE/STILL button to start
commences.3
recording.
If the setup menu item No. 110 OAUTO BACK�
is set to OALL,� the tape is first rewound two toThe tape travels to the position where the
three seconds from the position at which thePAUSE/STILL button was pressed in step 1, and
REC and PLAY buttons were pressed,recording commences.
advanced, and then recording starts from the<Notes>
point at which the REC and PLAY buttonsOThe E-E picture now appears on the screen.
were pressed. This ensures that there are noORecording with back-space assemble
gaps between recorded sections.recording from the 50 Mbps mode to the 25
(See page 31.)Mbps mode and vice versa is not possible.
6To stop recording, press the STOP button. 4Press the PAUSE/STILL button to pause
Recording now stops and the unit is set to therecording.
stop mode.If the setup menu item No. 110 OAUTO BACK� is
set to OREC-P� or OALL,� the tape is rewound two
<Notes>
to three seconds from the position at which the
OIt is not possible to select ANALOG for the video
PAUSE/STILL button was pressed and then
input signals and SDI for the audio input signals or
pauses.
vice versaN the same setting must be used for
both sets of signals.
OThe input signals cannot be recorded properly if a5Repeat steps 3and 4above to add recorded
recording inhibit signal is recorded with them.sections with no gaps in between.
OCheck that the SERVO lamp remains lighted during
recording. The pictures played back will be
disturbed if the lamp is flashing or off.
14 |
ACEC
