Before use
The units functions may be restricted by the type of camera recorder used. Before use, therefore,
check the camera recorder model and the functions which can be used with it.
ModelFunctions which can be used
AJ-D910WAMode 1All the units functions can be used. However, any old versions of
D610WAthe software must be upgraded so consult your dealer about this.
AJ-HDC20AMode 2Video signals cannot be output from the unit.
BS900All the units other functions can be used.
AJ-D810Mode 31. No VTR operations (START/STOP, FF, REW, STOP and PLAY
D700AREC CHECK) can be performed.
D7002. The GAMMA, KNEE SLOPE, KNEE POINT and DETAIL
D400controls cannot be operated.
3. The shutter speed is set to 1/60 or 1/100 when S.S. or S.V is
selected by the SHUTTER selector switch.
4. The FILTER settings cannot be displayed.
Only GAIN or IRIS can be selected for LED display using the
CHECK button.
5. The SETUP menus are not the units menus. The camera
recorders menus are output from the camera recorders VIDEO
OUT connector. Menus are not output to the units VIDEO OUT
connector.
6. Only L, M or H can be selected by the GAIN selector switch,
and these settings appear as 0, 9 and 18 on the LED display.
7. PAINTING is enabled at all times.
<Note>
Consult your dealer if a model not listed in the above table is going to be used.
E-3 |
ACEC
