Controls and their functions
(19)(20)
Front panel
POWER
ON
EJECT
OFF
AUTO OFF
SDHDCHANNEL CONDITIONVIDEOAUDIOSERVOHOMEMULCUETI ASSEM INSERTINPUT CHECKREMOTE(21)
VIDEOAUDIOLINE OUTAUDIOUNITY/VARADJUST
F13INOUTINOUT(22)
F12TC/CHRSET UPTESTDIAGSHTLJOGVAR
F11789FROMCOPY(23)
F10456/BS
F9123(18)
UNITYAUDIO MONITOR0CTFENT
LRF1F2F3F4F5F6F7F8
REC INHIBIT
HEADPHONESLEVELCURSOREXECUTEPREVIEWREVIEW PREROLLENTRYREWSTAND BYSTOPFFPLAYREC/EDIT
PULLOPENPULLOPEN
(18) Number keyseThese are used to enter numbers.
(0 to 9)
eCClear key for clearing input data.
eENTFor registering the data which have been entered.
eFUsed in combination with other keys.
eBSBackspace key
es rKeys for adding and subtracting
eFROM
eCOPY
eT
e/
(19) INPUT CHECKWhile these keys are kept depressed, the input signals can be checked.
It enables the video input signals to be checked at the SD SDI MONITOR OUT
connector or HD SDI MONITOR OUT connector and the audio input signals to be
checked at the MONITOR connector and headphone jack.
When the F7 (TCG OUT) key has been set to MOMNT on the TC/CHR SET UP
menu, the INPUT CHECK is established for the time code signals but only while
the INPUT CHECK key is held down. When the INPUT CHECK key is pressed
while the F7 key is set to LATCH, the INPUT CHECK mode is established, and
the mode remains established even when the key is released. The mode is re-
leased when one of the tape modes is established.
(20) REMOTE button eThis is the switch for switching between operation from the front panel of the
unit and operation from the remote control terminals (RS-422A, RS-232C) at
the rear connector panel.
eWhen REMOTE (lamp lit) is selected, the recorder can be controlled via the
remote control terminals at the rear connector panel.
eWhen LOCAL (lamp not lit) is selected, the recorder can be operated from the
front panel.
(21) AUDIO LINE OUT When the ADJUST control (23) is turned while this button is being pressed, the
output of all audio channels can be changed at the same time (HOME, AUDIO
OUT menus only).
(22) UNITY/VARThis is used to switch between UNITY and VAR when the video output signals or
audio level is to be adjusted.
(23) ADJUST control This is used to adjust the levels.
� 10� |
ACEC
