ó 1
�?´
Cassette tapes
Loading a cassette tape
1Check that there are no cables around the cassetteChecking for tape slack
holder or top panel, and set the POWER switch toGently push in the reel using your finger and turn the
ON.reel in the direction of the arrow. If the reel fails to
<Note>turn, it means there is no tape slack.
When condensation has formed inside the unit, the
HUMID display lights. Wait until this display is
cleared before proceeding with the intended
operation.
HUMID display
Ejecting the cassette tape
While the power is still on, press the EJECT button to
open the cassette holder, and take out the cassette
tape. If another cassette is not going to be loaded
immediately after this tape is ejected, close the
POWER: ONcassette holder.
Ejecting the cassette when the battery
has no charge
2Press the EJECT button.
First, set the POWER switch to OFF to turn off the
The cassette holder opens.
units power.
EJECT buttonThen turn the power back on, and immediately hold
down the EJECT button.
The cassette can be removed when there is still some
power left in the battery. However, do not repeat this
operation.
To prevent accidental erasure
Set the cassettes tab to SAVE to prevent the
recordings on the tape from being erased accidentally.
Cassette holder
REC
SAVE
3Insert the cassette tape and press the part marked
with the arrow to close the cassette holder
securely.
<Note>
Check that there is no slack in the tape of the
cassette.
80 |
ACEC
