P2Store Manager screens (continued)
Setup page
For checking and changing the unit's operating parameters.
Shock detection in USB mode section
Use [ON] and [OFF] to enable or disable impact
detection when the unit is connected to a
computer via the USB 2.0 cable.
[ON] (default):
Data transfer with the computer is suspended
if the unit is hit.
ENGLISH
[OFF]:
Data transfer is maintained even if the unit is
hit.
The unit�s current setting is displayed in the
�Current Setting� section.
If you change it, afterward click the [Apply]
button .
Note:
The possibility of HDD failure is higher with
High temperature mode sectionthe [OFF] setting than with the [ON] setting.
You can specify whether HDD operation isUse this setting at your own risk.
suspended or remains active if the internal HDD
Auto power off mode section
temperature exceeds a prescribed level.
You can specify the time until the unit switches
Options: [Suspend] and [Active]. Default:
OFF automatically if left unused (when no
[Suspend].
copying or formatting is in progress).
The unit�s current setting is displayed in the
Options: [Never], [5 min], [10 min], [15 min], [20
�Current Setting� section.
min], [25 min], and [30 min].
If you change it, afterward click the [Apply]
Default: [10 min].
button .
The unit�s current setting is displayed in the
Note:�Current Setting� section.
Setting to [Active] may result in failure of the
If you change it, afterward click the [Apply]
HDD.
button . Note that auto power OFF is
Use this setting at your own risk.
disabled when the unit is connected to a
Under Limit of HDD access sectioncomputer.
You can specify the minimum ambient
Initialize button
temperature at which HDD operation is
You can restore the default settings in sections
permitted.
, , and . However, note that the
Options: [5 deg / 41 F] and [-5 deg / 23 F].
setup details are not applied automatically.
Default: [5 deg / 41 F].
The unit�s current setting is displayed in theIf you change them, click the [Apply] button
�Current Setting� section. If you change it,
Apply button
afterward click the [Apply] button .
You can save the setup details in sections ,
Note:
, and on the unit as follows.
Setting to [-5 deg / 23 F] may result in failure
1. Click the [Apply] button
of the HDD.
A confirmation dialog is displayed.
Use this setting at your own risk.
2. Click [Yes]
The setup details are saved on the unit.
3. Restart the unit.
Note:
The new setup takes effect after the unit is
restarted.
E-26 |
ACEC
