Setup menus
USER menu<TIME CODE>
No./ItemDescription
511This selects how the VITC which is to beSBC (sub code data) area:
superimposed onto the output video signal isThis area is separate from the video and audio data area on the
VITC OUTto be output.helical track. The time code complying with SMPTE/EBU standards
is stored here. As with the conventional LTC (linear time code), the
0000SBC:time code can be read even during rewinding or fast forwarding. It
During recording:can also be read out when the tape has stopped.
The input time code, which was selected by
the setup menu No. 505 (EXT TC SEL)VAUX (video auxiliary data) area:
setting and TCG switch, is output as theThis area is to be found in the video data area on the helical track.
VITC.The additional information relating to the video data is stored here.
During playback:
The time code recorded in the SBC area is<Note>
output as the VITC.The time code and userOs bit are controlled during tape playback by
0001VAUX:the data which has been recorded in the SBC area. This means that
During recording:all the data recorded in the SBC area alone is used as the data
The time code detected from the input videowhich is to be indicated on the counter display section in the middle
signal is output as the VITC.of the front panel or in the superimposed display, or as the data
During playback:which is to be transmitted to the editing controller or other unit.
The time code recorded in the VAUX area is
output as the VITC.
<Note>
The time code detected from the input video
signal is automatically recorded in the VAUX area
while pictures are being recorded.
512This selects how the phase alignment for the
time code output from the TIME CODE OUT
TC OUT ADVconnector is to be handled.
Usually, it is aligned with the output video and
audio signals.
However, when external components are to be
connected, it is possible to align the phase with
the input signal.
0000OFF:
Phase alignment is not performed.
The time code output from the TIME CODE
OUT connector is aligned with the output video
and audio signals.
0001EDIT:
When editing mode has been selected, the
time code output from the TIME CODE OUT
connector is aligned with the input video and
audio signals during playback and editing
operations.
In all other modes it is aligned with the output
video and audio signals.
513This sets the operation mode which is to
make the internal time code generator
RUN MODEadvance.
0000REC:
The internal time code generator is advanced
during recording.
0001FREE:
When the power is on, the internal time code
generator is advanced regardless of the
operation mode.
The underlined items indicates the initial setting.
44 |
ACEC
