Chapter 5 Preparation
5-3Attaching the lens and
performing the flange
Adjusting the viewfinderOs front-back position
back and white shading
Loosen the viewfinder front-back position anchoring ring.
1
adjustments
Slide the viewfinder to the front or back, and adjust it to a
2Attaching the lens
position that allows easy viewing.
Raise the lever for securing the lens, and detach the
1
mount cap.
Tighten the viewfinder front-back position anchoring ring.
3
Viewfinder front-back position anchoring ring
Lever for
securing the lens
Mount cap
Align the center mark of the lens with the groove in the
2
top center of the lens mount, and attach the lens.
Removing the viewfinder
Mark
Loosen the viewfinder left-right position anchoring ring.
1
2While pulling up the viewfinder stopper, remove the
viewfinder by sliding it in the direction of the arrow.
Tighten the ring.
Viewfinder stopper
3Push down the lever for securing the lens to secure the
lens.
Release the viewfinder cable and mic cable from the
3
cable clamps, and disconnect the cables.
4Push the cable into the cable clamp, and connect it to the
LENS socket.
LENS socket
Proceed with the flange back adjustment for the lens.
5
<Notes>
eFor details on how to handle the lens, refer to the
operating instructions of the lens.
eWhile the lens is removed, attach the mount cap to
protect the unit.
60 |
ACEC
