#,52%--2
'PINKUJ DQQMMo+9Ţ9�9�9â9á?9�9�a?�?a?
? e9a(9a9á 1
Chapter 4 Adjustments and Settings for Recording (continued)
4-5 Setting Time DataCard continuity provided by the user bits
4-5-1 Setting the User BitsIf the menu option UB MODE is set to REGEN, the AJ-
SPC700P reads the user bits in the last frame of the last clip
recorded on a P2 card (clip with the most recent recording
The user bits allow information, including memos that use update and time), and records that bit onto the next card. Note
to eight-digit base 16 numbers (date and time), to bethat settings for the user bits are not recorded.
recorded in the Subcode area. The menu option UB MODE can be found in the <TC/UB>
screen, which is accessible from the MAIN OPERATIONHOLD switch
page.
DISPLAY switch
4<Note>
The AJ-SPC700P also records the time code and user bits
in the VIDEO AUX area. The value for the time code (VITC)
is the same as that of the time code (LTC) in the sub-code
area. The user bits (of VITC) also records special
Display
information, including the shoting frame rate.window
User bits of VITC
Card management data
z Frame update flag
TCG switchVerification z Recording start/stop
CURSOR and SET buttonsinformation on mark
the right-hand
six digits
1Position the DISPLAY switch at [UB].
Camera shooting mode
2Position the TCG switch at [SET].600:60iFixed value
When the left digit starts blinking you can change the
value.
3Use CURSOR buttons to set the user bits.
button: Shifts the target (blinking) digit to the right.
button: Shifts the target (blinking) digit to the left.
button: Advances the blinking number by one digit.
button: Winds back the blinking number by one digit.
4Position the TCG at [F-RUN] or [R-RUN].
5Go to the <TC/UB> screen from the MAIN OPERATION
page, and set the menu option UB MODE to USER.
<Note>
When the TCG switch is positioned at [SET],
thumbnails cannot be manipulated.
Retaining the user bits
The data set for the user bits are automatically saved and
retained even if the video camera-recorder is turned off.
37 |
ACEC
