Mounting
7 Install the board securely using the screws (B) ENGLISH
and 3 screws (C).
(At this stage, install the cable clamp as well.)
Screws (B)
Screws (C)
Cable clamp
8 Tighten the 6 screws (A) for the upper panel
cover securely.
Screws (A)
9 After attaching the required cables, insert the power connector and turn the power on.
For details on the setting and operating procedures, refer to the operating instructions of the AV-HS300G.
If the HD analog board has been connected properly, ANLG will appear at the OPT item on the
AV-HS300G s SETUP/STATS menu (5/5).
STATSALMOPTVER
15/15 NOANLG1.00
In order for the analog HD component signals to take effect, select ANLG (analog HD component) in the
MODE item setting for each of the input channels (IN to IN5) from the AV-HS300G s SETUP/IN-5 menu
(/5). Analog HD component signals and SDI signals cannot be used at the same time in the same input
channel.
Additionally, the gain of the input signals is set using the GAIN item.(The gain can be set within the
n 30-step range, and the setting will result in changes of n dB. The amount by which the gain changes per
step is not the same for each step.)
IN1-5SIGMODEGAIN
1/15 IN1 ANLG-30?30
IN2 SDI -
IN3
IN4
IN5
Removal procedure
Remove the HD analog board by following the procedures for mounting it in reverse.
6 (E) |
ACEC
