4Sharpness (DTL) Set Display3. Noise Suppress Level Setting
[Noise Suppress: OFF, LOW, HIGH]
1. Detail Select Setting
Screen noise can be reduced when Detail Level set-
[DTL Select: Sharpness, Super DTL]
ting (4-2) is at HIGH or LOW.
If contour correction is not sufficient at the
Sharpness position when Detail Level setting is set
4. Clean DNR Setting [Clean DNR: HIGH, LOW, OFF]
to LOW or HIGH, select the Super DTL position.
This enables the clean DNR effect to be selected.
Note
Neither Sharpness nor Super DTL is valid for
5. 3D-DNR Setting [3D-DNR: OFF, Low, Mid, High]
contour correction if Detail Level setting is in the
This enables the 3D-DNR effect to be selected.
OFF position.
H When OMid� or OHigh� is selected, the noise is
reduced but lag increases.
2. Detail Level Setting [Level: OFF, LOW, HIGH]
Detail level can be adjusted when Detail Select set-6. DTL Flesh Tone Setting
ting is at Normal. Super DTL level can be adjusted[DTL Flesh Tone: LOW, MID, HIGH]
when it is at Super DTL.LOW: The roughness of the flesh tones is minimized.
In case of using the RCU (RCB), the above can beMID: This is the standard setting.
adjusted with the contour correction switch (DTL).HIGH: The outline compensation for the flesh tones is
accentuated.
RCU (RCB)
DTL Switch
-39- |
ACEC
