Connections
9Pb OUT connector=CONTROL IN RS-232C connector
This is for camera video signal output.This is for RS-232C control signal input
Connect this to the Pb IN connector onfrom the personal computer.
the controller or to a monitor, etc.Use the AW-CA28T9 cable (option) for
Use a coaxial cable (BELDEN 8281) forthe connecting cable.
the connecting cable.The AW-CA28T9 is 10m long. When
extending the length, please use an
:G/L IN connectorRS-422, converting back to the
This is for genlock signal input.RS-232C at the pan/tilt head.
Connect this to the G/L OUT connector
on the controller.<Notes>
Use a coaxial cable (BELDEN 8281) forOThe personal computer can be
the connecting cable.connected with the controllers
AW-RP301/AW-RP305/AW-RP501/
;VIDEO OUT connectorAW-RP505 at the same time. (When
This is for camera video signal output.connecting with the controllers
Connect this to the VIDEO IN connectorAW-RP605A/AW-RP400 at the same
on the controller or to a monitor, etc.time, connect with controllerOs REMOTE
Use a coaxial cable (BELDEN 8281) forterminal.) In that case, the control source
the connecting cable.last used for operation is given priority.
OWhen the AW-RP301, AW-RP305,
<CAMERA CONTROL IN connectorAW-RP501 or AW-RP505 controller and
This is for camera control signal input.a personal computer are to be used at
Connect this to the CAMERAthe same time, the camera is controlled
CONTROL OUT connector on theby the controller if the controller is
controllers AW-RP501/AW-RP505, orconnected to the < CAMERA
multiport hub AW-HB505.CONTROL IN connector. If this
Use a coaxial cable (BELDEN 8281) forconnector is not connected, it is
the connecting cable.controlled by the personal computer.
OInformation such as pan/tilt head
position, lens zoom, focus, iris, etc. can
be accessed by the computer however,
white balance set by the controller
cannot be accessed.
- 25 - |
ACEC
