Installation
o Mounting the camera
[Multi-purpose camera AK-HC1500G]
When mounting the camera, take sufficient care to ensure that the camera will not come off or fall down.
1 Mount the lens onto the multi-purpose camera.
(1) Lenses that can be used
Use any of the portable lenses which are listed below.Note3 The current rating of LENS
I/F () connector is 500 mA
FujinonHA18, HA1, HA series(max).
CanonHJ17e, HJ1e seriesEven with the lenses in a
series which can be used,
(2) Lenses that cannot be used any lens whose maximum
Do not use the large-sized lenses [with a weight of 11 lbs (5 kg) or more current consumption
and a length of 15-/4 (400 mm) or more] with the model numbers exceeds 500 mA cannot be
which are listed below since when they are mounted on the camera, used.
the cameras overall balance will be upset.Concerning the maximum
current consumption of
FujinonHA4 seriesthe lens, contact the lens
CanonHJ40 series, J5 seriesmanufacturer.
2 Align the multi-purpose camera with the guide pins and mount it.
Change the positions of the guide pins and screws of the camera mounting base as shown in the figure below, and then
attach the camera mounting base to the rotary arm.
3 Do not use the rubber piece.
For a stand-alone installation
Camera Mounting base
Change the positions Set the guide pin.
of the guide pins.
Mount the camera
with the mounting
screws.
Mounting screws
Change the positions of the camera mounting
screws. (Change them over to the second row.)
3 Tighten up the two mounting screws securely using the tool.
For installation on the ceiling
Camera Mounting base
Set the guide pin.
Change the positions
of the guide pins.
Mount the camera with
the mounting screws.
Change the positions of the camera mounting
screws. (Change them over to the third row.)Mounting screws
3 Just as for a convertible camera, change the positions of the guide pins and screws of the camera mounting base as shown
in the figure above, and then attach the camera mounting base to the rotary arm.
0 |
ACEC
