INSTALLING THE DEVICE DRIVER
4When the screen for specifying the driver loading directory appears as shown in Fig.3,
This section describes how to install the device driver used with the USB image transfer
specify the \DRIVER folder of the drive where the CD-ROM supplied with the
program for the AW-SW350. In the example of the procedure given below, Windows XP is
AW-SW350 was inserted, and load the driver. (In this example, E: is the drive used.)
used as the operating system.
1Insert the CD-ROM supplied with the AW-SW350 in the CD-ROM drive of the host
computer. (In this example, E: is the drive used.)
2Set the AW-SW350's Power Switch to ON, check that the Power Indicator has lighted,
and connect one end of the A-B type USB cable to the USB port on the rear panel of
the AW-SW350 and the other end to the USB port on the host computer. (Fig.1)
BBOUTGLINPVW2 PGM OUT154321VIDEO
/BBOUTOUT
IN
TALLY & INCOM75&AUTOWindows PC
54321
OUTFig.3 Driver specification screen
DC 12V INUSBTEXTAKEPGMY / CY / C IN
SET UP1324OUT
GND54321
AW-SW350Rear5When the device driver has been loaded, a screen similar to the one shown in Fig.4
appears. This completes the installation of the device driver.
USB cable
Fig.1 Connections
3When the host computer recognizes the AW-SW350, as shown in Fig.2, the Found
New Hardware Wizard automatically starts up.
Fig.4 Driver loading completion screen
Fig.2 Found New Hardware Wizard start screen
2223 |
ACEC
