Operating Instructions
SettingDescription
Allow Access from "Allow Access from the Internet setting automatically
the Internet configures the router's Port Forwarding setting (some
(Automatic Setup routers call it "Address Translation", "Static IP
Only)Masquerade", "Virtual Server" or "Port Mapping"). To
enable Internet access to the camera, check [Yes]. In this
case, the camera automatically searches the unused port
number on your network in the order from 50000 to 50050.
To disable Internet access to the camera, check [No].
Network "If you prohibit the Setup Program from changing the
Configuration from network settings, clear the check box.
Setup Program
(Static/DHCP Only)
Port Number "You can set the camera port number (80 by default). When
(Static/DHCP Only)you use multiple cameras with a router on your network,
each camera must be assigned its own port number (see
page 11 "1.5 Connecting the Camera to a Router Not
Supporting UPnP" in the Installation/Troubleshooting).
"Do not set the following port numbers.
E.g., FTP: 20 and 21, Telnet: 23, SMTP: 25, DNS: 53,
POP3: 110, HTTPS:443, ICQ: 4000 and IRC: 66616667.
"Enter only the number (165535).
"Some ISPs do not allow you to use port 80. Ask your ISP
or network administrator about the accessible port number
over the Internet.
"IP address"If your ISP or network administrator specifies the IP
"Subnet Maskaddress and subnet mask, enter them in each data field.
(Static Only)"If you use the camera on the LAN, set the IP address in the
same class as your PC (see page 89).
"Set 4 digits (0255) and 3 periods such as
"192.168.0.253". But "0.0.0.0" and "255.255.255.255" are
not available.
Host Name"If your ISP uses the DHCP function which automatically
(DHCP Only)assigns the IP address to the camera, enter the ISP-
assigned host name. (Host name may be used as an
authentication.)
"Enter ASCII characters for the host name (see page 96).
But [Space], ["], ['], [&], [<] and [>] are not available.
30 |
ACEC
