REMOTE Specifications (continued)
g Assignment of item priority levels
When both ?MARKER1? and ?MARKER2? are ON at the same time, ?MARKER1? has priority.
When both ?MARKER BACKHALF? and ?MARKER BACKBLACK? are ON at the same time, ?MARKER
BACKBLACK? has priority.
When more than 2 of ?INPUT SEL. VIDEO?, ?INPUT SEL. Y/C?, ?INPUT SEL. SDI1?, ?INPUT SEL. SDI2?, ?INPUT
SEL. YPBPR/RGB? are ON at the same time, the one that was switched ON last has priority.
RS-232C terminal
Refer to the following diagram and lower right table for the RS-232C terminal pin arrangement and connections.
Please contact the vendor for information about detailed systems which used the RS-232C.
PC Side(Straight)BT-LH1700W Side
Pin numberSignalPin numberSignal
1N.C.1N.C.
2RXD2TXD
RS-232C Terminal (9P)3TXD3RXD
4DTR4DSR
5GND5GND
6DSR6DTR
7RTS7CTS
8CTS8RTS
9N.C.9N.C.
RS-232C REMOTE operation method
g Connectors and signal namesg Command format
Connector: D-SUB 9-pin (female)
Signal nameSTX (02h)Command :DataETX (03h)
Commands are 3 characters following STX, finally
Pin Signal
Explanationadding ETX. numbername
Add a : (colon) after the command as required, and
1N.C.Not connectedadd the data.
2TXDTransmission data
g Response formats
1. Setting command response3RXD Reception data
4DSR Connected inside.
STX (02h)CommandETX (03h)
5GND Ground
2. Query command response6DTRConnected inside.
STX (02h)DataETX (03h)
7CTSConnected inside.
8RTSConnected inside. 3. Error response
9N.C.Not connectedSTX (02h)Error codeETX (03h)
Error code
g Communication Conditions ER001: Invalid command
Signal levelConforms to RS-232CER002: Parameter error
Synchro systemTone pace synchro system
Transfer rate9600 bps
Parity None
Data length8 bit
Stop bit1 bit
Flow controlNone
E-23 |
ACEC
