Main Menu (continued)
INPUT SELECT
The underlined values are factory preset setting values.
Sub menuSettingsExplanation
VIDEO / Y/C<AUTO>Used to select the input format for VIDEO and Y/C input. *1
<NTSC><AUTO>Either NTSC or PAL is automatically selected.
<PAL><NTSC>NTSC<PAL>PAL
NTSC SETUP<75>Selects the NTSC setup level.
<00><75>Select this when using with a setup signal of
7.5 IRE. (The inner parts of the monitor are set
to the 7.5 IRE setup level to suit the black level)
<00>Select this when there is no setup level signal.
YPBPR/RGB<YPBPR>Selects either YPBPR (Component) or RGB input mode.
<RGB-VIDEO><YPBPR>Selects the YPBPR signal.
<RGB-COMP.><RGB-VIDEO>Selects the video RGB signal.
<RGB-COMP.>Selects the PC RGB signal.
COMPONENT <SMPTE>Selects YPBPR(Component) signal input level.
LEVEL<B75> <SMPTE>When the signal level specified in SMPTE is
<B00>Chroma 100 IRE PB, PR = 0.7 Vp-p.
<B75>Select this when connecting a betacam or
simliar devices set to 7.5 IRE. (The inner parts
of the monitor are set at 7.5 IRE setup level to
suit the black level)
<B00>Select this when connecting a betacam or similar
devices that are not setup to the IRE level.
RGB SYNC<G-ON>Selects the SYNC when using RGB-VIDEO input.
<EXT><G-ON>Select when a synchronizing signal is
superimposed on the G signal.
<EXT>Select when an external synchronizing signal is
received in synchronization.
COMP. Performs analog PC settings. (Refer to ?COMP.? below)
*1 ?AUTO? is set when the monitor is shipped from the factory, but if there are concerns about noise etc. from outside the
input signal, we recommend assigning specific format.
g COMP.
The following menus are switched by selecting ?RGB-COMP.? in ?YPBPR/RGB? in the ?INPUT SELECT? menu.
The underlined values are factory preset setting values.
Sub menuSettingsExplanation
*1
AUTOSETUPScreen automatic adjustment is performed when ?RGB-
COMP.? is selected in ?YPBPR/RGB? in the ?INPUT SELECT?
menu. ?AUTOSETUP? is performed if a different screen is
displayed, and ?YES? is selected.
H POSITION<0-60>Used to adjust the picture display position in the horizontal
*2
(Factory preset setting: 30)direction.
V POSITION<0-60>Used to adjust the picture display position in the vertical
*2
(Factory preset setting: 30)direction.
PHASE<0-31>Used to adjust the clock phase with 1/32 clock phases. *2
(Factory preset settings:
J page 28)
CLOCK<700-1800>Used to adjust the sampling clock in dot units. *2
(Factory preset settings:
J page 28)
WXGA/XGA<XGA>Switches between WXGA and XGA.
<WXGA>
*1 ?EXECUTING? is displayed while ?AUTOSETUP? is being executed, and ?COMPLETE? is displayed when
?AUTOSETUP? is completed. If ?AUTOSETUP? cannot be completed, ?INCOMPLETE? is displayed.
*2 Each ?RGB-COMP.? input compatible format can be adjusted, but you cannot load (?SETUP LOAD? J page 21)
or save (?SETUP SAVE? J page 21) the user data.
27
ACEC
