Parts and their functions
5 FUNCTION/ENTER button
This button is used to enter changes or settings while1234
a menu is displayed.
If there is no menu display, the button's function
changes depending on which FUNCTION item on the
PEAK/PHASECHROMABRIGHTCONTRAST
menu is selected. One of the following three items
can be selected. (Refer to page 19)
UNDEF:No function is allocated to this item.
4 Image controls
HV DELAY:Image blanking is displayed. Each time
These controls are used to adjust the peaking/color
the button is pressed, the blanking
phase, chroma, brightness and contrast. When a control
display is switched by one setting in the
is pushed in, it pops out to enable adjustment. When a
following sequence: H blanking display
numerical value is changed from the default setting, the
> V blanking display > H and V
lamp to the left of the control lights.
blanking display > no blanking display.
The adjustments performed using these controls are
WFM ON/OFF: The Y signal (luminance) waveform is
valid only when the controls are in the "out" position, and
displayed at the bottom right of the
when a control is pushed back in, the value adjusted by
image. When the button is pressed
that control is returned to its default setting.
again, the display is cleared.
When waveforms are displayed in the1 PEAK/PHASE (PEAKING/PHASE)
16:9 mode, the image displayed on theThis control is used to adjust the peaking or phase.
screen moves to the upper part of theWhich of these is to be adjusted is set using the
screen so that it will not bePEAKING/PHASE item on the SYSTEM CONFIG
superimposed onto the waveformscreen.
display.e PEAKING
This function is selected when the monitor is to be
used as a viewfinder.
It is used to set the edge sharpness. Any value
from 0 to 30 can be set: the higher the value, the
>sharper the edges. The default setting is 0.
e PHASE
This function is selected when the monitor is to be
WFM
used as a monitor.
It is used to set the color phase of the screen. Any
WFM function OFFWFM function ON
value from 0 to 60 can be set. The default setting
The image remains unchanged in the 4:3is 30.
mode.<Notes>
e When the blue-only function is ON, the control
functions as the PHASE control regardless of the
setting.
e The color phase cannot be adjusted when RGB
>
signals are input.
2 CHROMA
WFM
This control is used to adjust the image chroma. Any
WFM function OFFWFM function ONvalue from 0 to 60 can be set. The default setting is
30.
<Notes><Note>
e In order for this function to be used, it is necessary to
The chroma cannot be adjusted when RGB signals
select WFM as the FUNCTION item setting on the
are input or when the MONO setting is ON.
SYSTEM CONFIG screen, and then select FUNCTION
3 BRIGHT
as the WFM item setting.
This control is used to adjust the image brightness.
e The WFM function is a simplified one and, as such,
Any value from 0 to 60 can be set. The default setting
finely detailed waveforms may not be displayed
is 30.
accurately.
However, the brightness cannot be adjusted when
In addition, differences in the input signal format or
blanking is displayed using the HV DELAY function.
input function may result in the display having a
different horizontal width.4 CONTRAST
This control is used to adjust the image contrast. Any
value from 0 to 60 can be set. The default setting is
50.
6 |
ACEC
