2Connect the wireless display to a power outlet and turn onPower Switch
the wireless display. ( page 21)
3This screen should appear.
<Wireless display screen>
Select network type.
AdHocInfrastructureCancel
E
Select [AdHoc].
NOTE
The wireless display will turn off automatically after 10 minutes have elapsed. In
this case, start the procedure from step 2 .
4This screen should appear.
<Wireless display screen>
Change setting on host PC to the following
value, reboot the host PC, then select
"Connect" below.
Wireless LAN card
Network Type : AdHoc
SSID : cfvdw07-17498
WEP Encryption : disable
TCP/IPClass A Class B Class C
IP Address : 10. 98.185.105
NetMask : 255. 0. 0. 0
MeiWDS
AES Encryption : disable
Password : wdspAES: Advanced Encryption Standard
Connect Cancel
(This screen is a sample.)
Set the computer?s parameters for wireless LAN functions and TCP/IP.
Set Network Type, SSID, WEP Encryption, IP Address, and NetMask according to the
above screen. (In the above settings, Network Type is shown as ?AdHoc? in some cases,
while a term such as ?Peer-to-Peer Group? is used here.)
5Select [Connect] on <Wireless display screen> of step 4 .
19 |
ACEC
