P Radio
TroubleCause/Step
The antenna ground lead is not connected properly.
Much noise in FM stereoa Connect the antenna ground lead properly.
and monaural broad-
casts.The radio antenna is not extended enough.
a Extend fully the radio antenna.
Battery cable is not correctly connected.
Preset station is reset.
a Connect the battery cable to the terminal that is always active.
P Cassette Tape
TroubleCause/Step
Blank tape is inserted in the unit.
No sound.
a Insert recorded tape into the unit.
Heads are dirty.
a Clean heads. (Ask a service representative for advice.)
Tape sound quality is
poor.
Poor quality tape.
a Use better quality tape.
Reproduction of highHeads are magnetized.
tones is poor.a Demagnetize heads. (Ask a service representative for advice.)
Tape running mechanism is dirty or out of order.
Wow and flutter level is
a Clean tape running mechanism, or repair it. (Ask a service represen-
very high.
tative for advice.)
P Sound Setting
TroubleCause/Step
Left and right balance, or front and rear balance is off on one side.
a Adjust BAL/FAD as appropriate.
No sound from left, right,
front, or rear speaker.
Cables are not correctly connected.
a Connect the cables correctly.
Left and right sounds areThe right speaker wire is connected to the left speaker and the left speaker
reversed in stereo listen-wire to the right speaker.
ing.a Connect the speaker wires to the correct one.
15
CQ-2130U |
ACEC
