QC13OegM9% 02/05 :9P Â?5
Troubleshooting
If You Suspect Something Wrong
Check and take steps as described below.Warning
�Do not use the unit in an irregular condition, for example,
If the described suggestions do not solve the problem, it is recom-
without sound, or with smoke or a foul smell, which can cause
mended to take the unit to your nearest authorized Panasonic
ignition or electric shock. Immediately stop using the unit and
Servicenter. The product should be serviced only by qualified person-
consult your dealer.
nel. Please refer checking and repair to professionals. Panasonic
�Never try to repair the unit by yourself because it is dangerous
shall not be liable for any accidents arising out of neglect of checking
to do so.
the unit or your own repair after your checking.
Note: For whatever is printed in italics in �Check point� column,
Conduct the operations and checks by yourself.
TroubleCheck pointTroubleCheck point
CommonDisc Player
�Start the engine. (Or turn the ignitionNo sound, or disc
�Load the disc correctly.
switch to the ACC position.)is automatically
�Clean the disc.
�Verify the wiring. (Ex. battery lead,ejected
power lead, ground lead, etc.)
No power
�Fuse blown (Contact the nearestSound skip,
Panasonic Servicenter.)poor sound�Clean the disc.
�Ask a professional for fuse replacement.quality
�Be sure to use the same rated fuse.
Sound skip�The maximum permissible tilt angle is
�Disable the mute function.due to30�.
�Verify the wiring.vibration�Secure the unit.
No sound
�Wait until the dew disappears before
turning on the unit.�Press [u]. If the disc is still not ejected,
Disc not
contact the nearest Panasonic
�Make sure that grounding is establishedejectable
NoiseServicenter.
properly.
No sound fromError Display Messages
�Adjust the balance and fader.
left, right, front,
�Verify the wiring.
or rear speaker
(The disc is ejected automatically.)
Left and rightThe disc is dirty, or is upside down.
sounds are�Connect the speaker lead correctly.The disc has scratches.
reversed�Check the disc.
Radio
No operation by some cause.
�Tune into another station of high-inten-
�If normal operation is not restored, call
Frequentsity waves.
the store where you purchased the unit
noise�Make sure that the antenna mounted
or the nearest Servicenter to ask for
point is grounded properly.
repairs.
�The preset memory is cleared to return
Preset datato the original factory setting when the
are deletedpower connector or battery is discon-
nected. |
ACEC
