QDo not install the product where it is exposed to
Cautionstrong vibrations or is unstable.
Observe the following cautions when using thisAvoid slanted or strongly curved surfaces for installation. If
the installation is not stable, the unit may fall down while
unit.driving and this can lead to an accident or injury.
QKeep the sound volume at an appropriate level.QInstallation Angle
Keep the volume level low enough to be aware of road andThe product should be installed in a horizontal position withEnglish
traffic conditions while driving.the front end up at a convenient angle, but not more than
QDo not insert or allow your hand or fingers to be30u.
The user should bear in mind that in some areas there may
caught in the unit.
To prevent injury, do not get your hand or fingers caught inbe restrictions on how and where this unit must be installed.
Consult your dealer for further details.
moving parts or in the disc slot. Especially watch out forQWear gloves for safety. Make sure that wiring is
infants.
QThis unit is designed for use exclusively in automo-completed before installation.
QTo prevent damage to the unit, do not connect the
biles.
QDo not operate the unit for a prolonged period withpower connector until the whole wiring is complet-
ed.
the engine turned off.
Operating the audio system for a long period of time with theQDo not connect more than one speaker to one set of
engine turned off will drain the battery.speaker leads. (except for connecting to a tweeter)
QDo not expose the unit to direct sunlight or exces-
sive heat.Observe the following cautions when handling
Otherwise these will raise the interior temperature of thethe battery for the remote control unit.
unit, and it may lead to smoke, fire, or other damage to the
unit.IUse only specified battery (CR2025).
IMatch the polarity of the battery with the (+) and (�) marks
QDo not use the product where it is exposed to water,in the battery case.
moisture, or dust.IReplace dead battery as soon as possible.
Safety Information
Exposure of the unit to water, moisture, or dust may lead toIRemove the battery from the remote control unit when not
smoke, fire, or other damage to the unit. Make especiallyusing it for an extended period of time.
sure that the unit does not get wet in car washes or on rainyIInsulate the battery (by placing them in a plastic bag or cov-
days.ering them with vinyl tape) before disposal or storage.
Observe the following cautions whenIDispose of the battery according to the local regulations.
IDo not disassemble, recharge, heat or short the battery. Do
installing.
not throw a battery into a fire or water.
QRefer wiring and installation to qualified serviceIn case of battery leakage
personnel.IThoroughly wipe the battery liquid off the battery case and
Installation of this unit requires special skills and experience.insert new battery.
For maximum safety, have it installed by your dealer.IIf any part of your body or clothing comes into contact with
Panasonic is not liable for any problems resulting from yourbattery liquid, wash it with plenty of water.
own installation of the unit.IIf battery liquid comes into contact with your eyes, wash
QFollow the instructions to install and wire the prod-them with plenty of water and get immediate medical atten-
uct.tion.
Not following the instructions to properly install and wire the
product could cause an accident or fire.
QTake care not to damage the leads.
When wiring, take care not to damage the leads. Prevent
them from getting caught in the vehicle chassis, screws, and
moving parts such as seat rails. Do not scratch, pull, bend or
twist the leads. Do not run them near heat sources or place
heavy objects on them. If leads must be run over sharp
metal edges, protect the leads by winding them with vinyl
tape or similar protection.
QUse the designated parts and tools for installation.
Use the supplied or designated parts and appropriate tools
to install the product. The use of parts other than those sup-
plied or designated may result in internal damage to the unit.
Faulty installation may lead to an accident, a malfunction or
fire.
QDo not block the air vent or the cooling plate of the
unit.
Blocking these parts will cause the interior of the unit to
overheat and will result in fire or other damage.
3CQ-C7403U/C7303U/C7203U/C7103U |
ACEC
