Note: If no operation takes place for more than 5 sec-EE
onds in audio mode (2 seconds in volume mode), theNN
Power and Sound ControlsClock Setting
GG
display returns to the regular mode.
LL
II
SS
The 12-hour system is used for the clock.
PowerAudio Mode HH
Display Change
Turn the key in the ignition until21
Press [DISP] (display) to switch to the clock display.(Bass/Treble/Balance/Fader/Sub Woofer)Initial Time
the accessory indicator lights.
Power on: Press [SRC] (POWER).When the power is off:Push [SEL] to select the audio mode.qqPress [DISP] (clock).
Power off: Press [SRC] (POWER)VolumeBassTreble
again and hold.
Sub WooferFaderBalance
No displayClock displayPush"AdJ" is displayed when the clock is not
(Only for CQ-DPX153U)
ACCadjusted.
ONNote:
Please refer to next page when "AdJ" is displayed.
[k TUNE], [l TUNE] (Hours, minutes)
Remote control sensor
(only for CQ-DP133U/DPX153U)
SELEPUSH
DVOLUMCQ-DP133U
BANDYM
APM
TUNETUNE
VOLUSELMEPUSHTRTRAACCKK
NDCQ-DP133UPOWERCLOCK
BADYMSRC789101112SCANREPSP
APMMUTE123465LOUDDIDISP
TUNE
TRACK
POWERCLOCK
SRSRC789101112SCANREPP
CDDIISSP
MUTEMUTE123465LOUDLOUDTurn the knob clockwise or conterclockwise to[DISP] (clock)
w
change each level.
Hours
Bass:
VolumeLoudnesswPress and hold [DISP] (display) for more than
2 seconds.
Turn the knob clockwise to increase volume,Press [LOUD] to enhance bass and treble tones atAdjustable range: �12 to +12 (by 3dB step)
and counterclockwise to decrease volume.low or medium volume.
Treble:(Hours blink.)
ePress [kTUNE]or [lTUNE].
LOUD
Volume level (0 to 40)
lightsAdjustable range: �12 to +12 (by 3dB step)(Hours set.)
Balance:
Press [LOUD] again to cancel.R (right speaker) or L (left speaker)Minutes
rPress [DISP] (display).
UpMute
DownPress [MUTE] to mute the sound completely. Adjustable range: 1 to 15 (by 1 step) Balance center
(Minutes blink.)
Fader:
MUTEtPress [kTUNE]or [lTUNE].
Anti-volume-blast circuit:F (front speaker) or R (rear speaker)
When the power is switched off and on(Minutes set.)
lights
again, the volume slowly rises to the previ-
yPress [DISP](display).
ous level.
Press [MUTE] again to cancel.Adjustable range: 1 to 15 (by 1 step) Fader center
The anti-volume-blast circuit will not work
when the volume level is set lower thanSub Woofer:(End.)
position 20 on the display.(Only for CQ-DPX153U)Note: Press and hold [k TUNE] or [l TUNE] to
change numbers rapidly.
Time Reset
Adjustable range (level): MUTE (0) to 8Press and hold [DISP] (display) for more than
2 seconds to activate the time setting mode to
reset the time. Then, repeat steps e to y.
1110
CQ-DP133U/DP103U/DPX153UCQ-DP133U/DP103U/DPX153U |
ACEC
