Installation Installation (continued)(continued)
EPreparationeWe strongly recommend that you wear gloves
Nfor installation work to protect yourself from
GeBefore installation, check the radio operation
Lwith antenna and speakers.injuries.
I
SeDisconnect the cable from the negative -
Hbattery terminal (see caution below).
39eUnit should be installed in a horizontal positionFirst complete the electrical connections, and then
with the front end up at a convenient angle, butcheck them for correctness. (� page 62)
not more than 30o.
30�or less
Caution
eDo not disconnect the battery terminals of a
car with a trip or navigational computer since
all user settings stored in memory will be lost.
Instead take care with installing the unit toLock Lever (§)
prevent shorts.
: Power Connector
Dashboard Installation
Installation Opening
This unit can be installed in any dashboard having
an opening as shown at right. The dashboard should
be 4.5 mmj6 mm thick in order to be able to
support the unit.
Installation Precautions
This product should be installed by a professional
installer, if possible.
In case of difficulty, please consult your nearest
authorized Panasonic Service Center.
1.This system is to be used only in a 12-volt, DC
battery system (car) with negative ground.
2.Follow the electrical connections carefully.
(� page 62)
Failure to do so may result in damage to the unit.
3.Connect the power lead after all other connections
are made.
4.Be sure to connect the battery lead (yellow) to the
positive terminal + of the battery or fuse block
(BAT) terminal.
5.Insulate all exposed wires to prevent short
circuiting.
6.Secure all loose wires after installing the unit.
7.Please carefully read the operating and the
installation instructions of the respective
equipment before connecting it to this unit.
58
CQ-DVR909U |
ACEC
