INSTALLATION
Installation
Television LocationCable / Antenna Connection
This unit is intended to be used with an optional stand orFor proper reception, either a cable or antenna connection
entertainment center. Consult your dealer for availableis required.
options.Cable ConnectionIncoming Cable from
?Avoid excessive sunlight or bright lights, includingCable Company
Connect the cable supplied by your local
reflections.cable company. Tighten with fingers only.
?Keep away from excessive heat or moisture. Inadequate
Use of any tool (e.g. pliers) for tightening
ventilation may cause internal component failure.may result in tuner damage.
?Fluorescent lighting may reduce remote control75 Ohm VHF/UHF
transmitting range.Note: A cable converter box may beon back of TV
required for proper reception.
?Keep away from magnetic equipment, including motors,Check with your local cable
fans and external speakers.
company for compatibility requirements.
WARNING: Use this television receiver only with the
cart, stand, tripod, bracket, or table specified by theAntenna Connection
ENGLISH?For proper reception of VHF/UHF channels, an
manufacturer, or sold with the apparatus. When a cart
is used, use caution when moving the cart/apparatusexternal antenna is required. For best reception an
outdoor antenna is recommended.
combination to avoid injury from tip-over. In order to
avoid injury to children, never place your television receiver on a?Connect home antenna toIncoming Cable from
piece of furniture that is capable of being tilted by a child leaningANT connection on back ofHome Antenna
television. Select TV mode in
on it, pulling on it, standing on it, or climbing on it. A falling
television can cause serious injury or even death. the SET UP menu.
Note: Cable Mode is preset at the
CT-32HC14, CT-32HC14U:
factory. Antenna users must
CAUTION: These television receivers for use only withchange to TV Mode in the Set
PANASONIC TY-32HL43T stand. Use with other cartsUpmenu (page 19).
(or stands) is capable of resulting in instability causing
possible injury.Remote Control Battery Installation
Requires two AA batteries (supplied).
Battery Polarity
Optional Cable Connections
Shielded audio and video cables should be used between
components. For best results: / 1.5AAA
?Use 75-ohm coaxial shielded cables.
?Use appropriate input and output connectors, that matchAA / 1.5A
your component connectors.
12
?Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK, / 1.5AAA
MATCH WIDE BLADE OF PLUG TO WIDE SLOTAA / 1.5A
OF AC OUTLET AND FULLY INSERT. DO NOTPolarized plug
USE A PLUG WITH A RECEPTACLE OR OTHER3
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLEDProcedure
1. Turn the remote control face down. Remove battery
OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,
CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXITcover by pressing down on the marking on the cover
FROM THE APPARATUS.and sliding it off in the direction indicated.
2. Install batteries matching (+) and (-) polarity signs.
3. Replace the battery cover by sliding in reverse until the
lock snaps.
Note: Incorrect installation can cause battery leakage and
corrosion that will damage the Remote Control.
Precautions
?Replace batteries in pairs.
?Do not mix battery types (zinc carbon with alkaline).
?Do not recharge, heat, short-circuit, disassemble, or
burn batteries.
4 z |
ACEC
