REMOTE CONTROL OPERATION
Programming The Remote Control
The Universal Remote Control can be programmed to7. Press VOL X (the mode key will blink three times), then
operate many manufacturers? components, using the
press the Remote Control POWER button to test the
component function buttons for VCR, DVD, CABLE or
DBS. Follow the procedures for programming your Remotecomponent. Continue this process until the proper code
is found. If the procedure was successful, the component
Control with or without a code for the component.
will turn on.
DeviceOperatesDefault
Note: Each time you press the VOL X button, make sure that
TVTV (Panasonic Only)Panasonic Codethe component key blinks twice before pressing the
VCRVCR (Preset)Panasonic Code POWER button.
ACTION
DBS/CBLDBS STB & CBL STB (Preset)Panasonic DBS Code
8. Once the device responds, press to store the
DVDDVD (Preset) Panasonic Code
code. The mode (component) button will blink twice.
Note: Determine the manufacturer of the component and look
Note: It may take many attempts before the correct code
in the table for the code (found on page 12).
isfound. If you miss a code, press W VOL, then press
ProcedureENGLISH
POWERthe button to test the component.
1. Confirm that the external component is plugged in and
operating.
Component Codes
2. Turn the component off.
ACTIONThe Universal Remote Control is capable of operating
3. Press and POWER together, for at least 5
many component brands after entering a code. Some
seconds. After 5 seconds, the illuminated modecomponents may not operate because the codes are not
(component) buttons will begin to flash. Release the
available due to limited memory. The Universal Remote
ACTION and POWER buttons.Control does not control all features found in each model.
4. Press appropriate component button on the Remote
Control VCR, DVD, CABLE or DBS. The component
button will illuminate steadily and all others will go out.Write the code numbers from tables in this space.
5. Enter the 3-digit component code using the RemoteThis will serve as a reference if you need to program
Control numeric keypad (0 ~ 9 buttons). The componentyour Remote Control.
button will blink twice.
VCR CABLE DVD
6. Press the Remote Control POWER to test the
component. If the procedure was successful, the
component will turn on and the component key will blink
DBS
twice and then go out.
Note: If the component does not operate with the Remote
Control, repeat steps 3 through 6 using another code
(some brands have multiple codes). If an incorrect code
is entered, or if the procedure takes longer than 30
seconds, the programming will fail.
Programming Without A Code
This procedure searches all codes and is called the
?sequence method.?
1. Confirm that the external component is plugged in and
on.
2. Turn the component off.
ACTION
3. Press and POWERtogether, for at least 5
seconds. After 5 seconds, the illuminated mode
(component) buttons will begin to flash. Release the
ACTION and POWER buttons.
4. Press the appropriate component button on the Remote
Control. The component button will illuminate steadily
and all others will go out.
5. Press the POWER button to set the remote control into
the step and set mode.
6. Point the remote control towards the component.
11 z |
ACEC
