REMOTE CONTROL OPERATION
Programming the RemoteProgramming without a Code
The Universal Remote Control can be programmed toThis procedure searches all codes and is called the
operate many manufacturers? components using the?sequence method.?
component function buttons for VCR, DVD, AUX, RCVR,
Procedure
DTV, CABLE or DBS. Follow the procedures for
1. Confirm that the external component is plugged in and
programming your Remote Control with or without a code
on.
for the component.2. Turn the component off.
Default Modes for Remote ControlACTION
3.Press and POWER together, for at least 5
DeviceOperatesDefault
seconds. After 5 seconds, the illuminated mode
TVTV (Panasonic Only)Panasonic TV Code
(component) buttons will begin to flash. Release the
DTV-STBDTV (Panasonic Only)Panasonic DBS Code
ACTION and POWER buttons.
Panasonic CABLE 4. Press the appropriate component button on the Remote
CABLECABLE (Preset)
Code
Control. The component button will illuminate steadily
DBSDBS (Preset) Panasonic DBS Codeand all others will go out.
ENGLISHVCRVCR (Preset)Panasonic VCR Codes
5. Press the POWER button to set the remote control to the
DVD/CDDVD and CD (Preset)Panasonic DVD Codes
step and set mode.
Personal Video Recorders, Panasonic Personal
AUX6. Point the remote control towards the component.
Tape and VCR2Video Recorder Code
7.Press VOL X (the mode key will blink three times), then
RCVRAudio receiver (Preset)Panasonic RCVR code
Note: Determine the manufacturer of the component and lookpress the Remote Control POWER button to test the
in the table for the code.component. Continue this process until the proper code
is found. If the procedure was successful, the component
Programming with a Code
will turn on.
ProcedureNote:Each time you press the VOL X button, make sure that the
1. Confirm that the external component is plugged andcomponent key blinks twice before pressing the POWER
operating.button.
2. Turn the component off.ACTION
ACTION8. Once the device responds, press to store the
3. Press and POWER together for at least 5code. The mode (component) button will blink twice.
seconds. After 5 seconds, the illuminated modeNote: It may take many attempts before the correct code
(component) buttons will begin to flash. Release theisfound. If you miss a code, press W VOL, then press
ACTION and POWER buttons.
the POWER button to test the component.
4. Press appropriate component button on the Remote
Control VCR, DVD (CD), AUX (VCR2 or TAPE), RCVR,
DTV, CABLE or DBS. he component button willComponent Codes
illuminate steadily and all others will go out.
The Universal Remote Control is capable of operating
5. Enter the 3-digit component code using the Remote
many component brands after entering a code. Some
Control numeric keypad (0 ~ 9 buttons). The component
components may not operate because the codes are not
button will blink twice.
available due to limited memory. The Universal Remote
6.Press the Remote Control POWER to test the
Control does not control all the features found in each
component. If the procedure was successful, themodel.
component will turn on and the component key willWrite the code numbers from tables in this space.
blink twice and then go out.This will serve as a reference if you need to program
Note: If the component does not operate with the Remoteyour Remote Control.
Control, repeat steps 3 through 6 using another code. VCR DVD DVD (CD)
(Some brands have multiple codes). If an incorrect code
is entered, or if the procedure takes longer than 30
seconds, the programming will fail.
AUX (VCR2) AUX (TAPE) RECEIVER
CABLE DBS AUX (PVR)
14 z |
ACEC
