PREPARATION BEFORE OPERATIONHOW TO OPERATE Setting Temperature
Y Press 3 to increase or decrease the temperature.
Y The temperature can be set between 60!F ~ 86!F.
Indoor Unit
Y Recommended temperature:
A
OHEAUT
ONTCOOL
75!F ~ 78!F
OFFAUUTTODRYFANCOOL
212
POWTEMPFAANAUUTTO2!F ~ 4!F
ERFULN
6
3MODEDRYLower than the
OFF/ON
35AUTOAIR SWINGECONOMYroom temperature
ON1MANUAL1
5 4OFF2SLEEP6
FAN SPEED
RESETTIMERSET4Y During AUTO Operation, press 3 to select:-CHECK3
CANCEL
CLOCK
1Connect the power supply cord to an independent
power supply
Y Operation with 4!F higher than the standard
To start the operation
temperature.
2Open the front panelY Press 1.
Y POWER indicator (green) on the indoor unit will light
Y Operation with the standard temperature.
up.
3Remove the air filters
Y To stop, press once more.
AUTOHEATCOOLDRYFANY Operation with 4!F lower than the standard
AUTO
temperature.
4Fit the air purifying filters in place Setting Mode
Y Press 2 to select:-
5Insert the air filtersAUTO
FAN
Standard Temperature
AUTO � Automatic Operation
6Close the front panel
COOL � Cooling OperationStandard
Indoor
DRY� Soft Dry OperationtemperatureOperationtemperature
Remote ControlFAN� Air Circulation Operation
Cooling77!F
� To set the current time
73!FSoft Dry72!F
AIR SWING
AUTOMANUALFAN SPEED
123
Y Once the Automatic Operation is selected, the
ONSET
indoor temperature sensor operates automatically
OFFCANCELto select the desired operation mode with Cooling
TIMER2
or Soft Dry.
1Y After the operation mode has been selected, the
CHECKRESET CLOCK
mode does not change.
1Press 1.
2Then press 2 to increase or decrease the time.
3Press 1 again.
Set time at display will light up.
5 |
ACEC
