ENGLISH
Setting the Fan Speed Use this air conditioner under the following Operation Details
Y Press 4 to select:-conditions:
FAN� Low Fan SpeedCOOL � Cooling Operation
FAN� Medium Fan Speed
Y To set the room temperature at your preference
FAN� High Fan Speed
Cooling Modelcooling comfort.
AUTO
FAN� Automatic Fan Speed(Unit in !C)
AUTO � Automatic OperationThe speed of the indoor fan is adjusted
automatically according to the operation.IndoorOutdoorY Sense indoor temperature to select the optimumDBT: Dry Bulb Temp
The indoor fan stops occasionally duringWBT: Wet Bulb Tempmode.
DBT WBT DBTWBT
cooling operation.Y Temperature is not displayed on the remote control
Maximum Temperature322326during AUTO operation.43
Setting the Vertical Airflow Direction.
Y Press 5 to select:-Minimum Temperature16111611DRY � Soft Dry Operation
Y A very gentle Cooling Operation, prior to
AUTOdehumidification. It does not lower the room
temperature.
Y During Soft Dry operation, the indoor fan operates at
Heat Pump ModelLow fan speed.
AUTOY For COOL/DRY operation.
Swing up/down automatically.(Unit in !C)
HEAT � Heating Operation
AUTOY For HEAT operationIndoorOutdoor(for Heat Pump Model only)DBT: Dry Bulb Temp
(For Heat Pump Model only)Y Heat is obtained from outdoor air to warm up theWBT: Wet Bulb Temp
DBTWBTDBTWBT
When the discharge air temperature isroom. When the outdoor ambient air temperature
low such as at the start of the heatingMaximum Temperature-Cooling32234326falls, the heating capacity of the unit might be
operation, the air blows at horizontal(Maximum Temperature-Heating) (30)(-)(24) (18)reduced.
level. As the temperature rises, the hot
Y Defrosting Operation
air blows in a downwards direction.Minimum Temperature-Cooling16111611
Depend on the outdoor temperature, the operation
(Minimum Temperature-Heating)(16)(-)(-5)(-6)
occasionally stops to melt the frost on the outdoor
Setting the Horizontal Airflow Direction.
unit.
Y Press 6 to select:-
FAN � Air Circulation Operation
Notes(for Cooling Model only)
Indoor
Y If the unit is not going to be used for an extendedY When the room temperature reaches the set
HorizontalUnit
period of time, turn off the main power supply. If it istemperature, operation commences at Low airflow
Airflow
left at the ON position, approximately 2.5 W of
DirectionRemoteAUTOvolume. It stops when the room temperature drops to
electricity will be used even if the indoor unit has been
Control2!C below the set temperature.
turned off with the remote control.
(It is useful when using a heater).
Y If operation is stopped, then restart immediately, the
unit will resume operation only after 3 minutes.
AUTOY For COOL/DRY operation.
Swing left/right automatically.
AUTOY For HEAT operation
(For Heat Pump Model only)
There is no air swing during the discharge
air temperature is low. When the
temperature rises, the horizontal airflow
louvers swing left/right automatically.
6 |
ACEC
