HELPFUL INFORMATIONENERGY SAVING AND OPERATION
HINTS
Auto Operation Button Auto Restart Control
Y If power is resumed after a power failure, the
Setting the Temperature
ECONOMYECONOMYECONOMYECONOMYPOPOPOPOWERFULWERFULWERFULWERFULPOPOPOPOWERWERWERWER SLEEPSLEEPSLEEPSLEEPTIMERTIMERTIMERTIMERoperation will restart automatically after 3 - 4Y Approximately 10% of electricity can be saved.
minutes.Y Set the temperature higher or lower than the
Y Raise the front panel and press.Y Operation will be restarted automatically under thedesired temperature.
previous operation mode and airflow direction when
power is resumed as the operation is not stopped
Automatic Operationby the remote control.
Y If the remote control fails to function or has beenCooling Model
misplaced, press the Auto Operation button to start Timer Setting
Cooling Operation : 1!C higher
the Automatic operation.Y When power failure occurs, the timer setting will be
Y The Automatic operation will be activatedcancelled. Once power is resumed, reset the timer.
immediately once the Auto operation button isHeat Pump Model
pressed. However, temperature cannot be adjusted Thunder and Lightning
in this operation.Y This air conditioner is equipped with a built-in surgeCooling Operation : 1!C higher
Y The power indicator on the indoor unit will blink untilprotective device. However, in order to furtherHeating Operation : 2!C lower
the operation mode is selected automatically.protect your air conditioner from being damaged by
Y To cancel this operation, press once more.abnormally strong lightning activity, you may switch
off the main power supply and unplug from power Air Filters and Air Purifying Filters
Remote Control Signal Receiving Soundsocket.Y Clean the air filters every 2 weeks and the Air
Y To switch off the beep (Signal Receiving Sound),Purifying Filters every 6 months.
press the Auto Operation button for 10 secondsY Dirty filters may reduces cooling or heating
continuously or longer.efficiency.
OBeep�, Obeep� sound will be heard at the tenth
seconds. Keep All Doors and Windows Closed
Note: OBeep� sound will be heard at the fifthY Otherwise, cooling or heating performance will be
seconds;reduced and electricity cost is wasted.
However please press continuously until you
heard Obeep�, Obeep� sound. Outdoor Unit
Y Repeat the above steps if you want to switch on theY Do not block the air outlet vents. Otherwise, it will
Signal Receiving Sound.lower the cooling or heating performance.
(This is for Servicing purposes only.) Timer and Sleep Mode
Note: If you press this button continuously for 5 to 10Y To prevent wastage of electricity, use sleep mode
seconds, Test Run operation will be performed.when sleeping or Timer when going out.
A Obeep� sound will be heard at the fifth seconds
indicating the Test Run starts to operate. Avoid Direct Sunlight
Y Keep curtains or drapes closed to avoid direct
sunlight during cooling operation.
9 |
ACEC
