EE
NN
Installation (continued)
GG
LL
II
SS
HConnectthewiresandattachthemainunit.H3 Insert the bosses of the main unit underside in
5
the base plate guide holes.
1516
1 Connect the wires (page 30 to 35) which Caution:
were pulled out in a previous step to the unit Push in any extra wire.e Ifthereisanyextrawiring,pushit
(page 24).fromthepulloutopeningtobehind
theceiling,takingcaresothatitisnot
Caution:pinchedbetweenthemainunitandbase
plate.Failuretoheedthiscautionmay
e Whenconnectingstrippedwires,besure
resultinanaccidentand/orinjury.
towrapthemsecurelywithelectrical
tapetopreventshorts.
1
Noteforconnectingthedomelights
(page30s 31):
e There are two common types of dome
light circuits used, positive or negative
switched.
Positive systems supply voltage to the
See page 30` 31.
interior lights to turn them on, negative
switched systems apply ground to
illuminate the bulbs.
e The dome light lead connection varies
depending on the type of vehicle. Consult
1
a service technician as needed.
4 Use a screwdriver to tighten the screws
e Both positive and negative switched
(in 6 positions) that you previously tightened
light circuits are supported by this
loosely to secure Ţ rmly the main unit.
unitOs door switch. If the door switch
is not wired correctly, the dome
light will not come on properly.
The polarity differs from one model to
2
another so be absolutely sure to ask a
dealer or service technician to wire and
install the unit.
Where the wires emerge
< Cord clamp 2 Bind the wires using the cord clamps (<) after 5 Insert the end of the panel, and push it
in the front seat side
a 2connecting.back into place as shown in the Ţ gure.
(at 2 positions)
1
Bend the cord clamps about 5 mm {/ q} from Secure the screws.4
their ends, pass the cord clamps through the
installation holes in the main unitOs rear panel,
Note:
and then use them to secure the wires. Finally, e Be careful not to scratch the surface of
cut off the excess parts of the cord clamps.the front cover when attaching it.
Where the wires emerge
Caution:
in the rear seat side
< Cord clamp
a 1(at 1 position)e Wiresarenevertobehitbythescrews
orpinchedbetweentheplates.
2829
CY-VHD9401U/LCY-VHD9401U/L |
ACEC
