Others
[MEMORY CARD ERROR FORMAT THIS ? Depending on the type of Card, recording
CARD?]may stop in the middle.
The format of the card cannot be
recognized by this camera. Format the [A FOLDER CANNOT BE CREATED]
card again with this camera.A folder cannot be created because there
are no remaining folder numbers that can
Save your data to your computer, then use be used. (P85)
this unit to reformat the card. (P83)
Save your data to your computer, then use
[PLEASE TURN CAMERA OFF AND this unit to reformat the card. (P83)
THEN ON AGAIN]If you execute [NO.RESET] in the [SETUP]
This message appears when the camera menu after formatting, the folder number is
is not operating properly. Turn the camera reset to 100. (P22)
off and on. If the message persists, contact
the dealer or your nearest Service Center.[PICTURE IS DISPLAYED FOR 4:3 TV]/
[PICTURE IS DISPLAYED FOR 16:9 TV]
[MEMORY CARD ERROR ? The video cable is connected to the
MEMORY CARD PARAMETER ERROR]camera. Press [MENU/SET] if you want
Use a card compatible with this camera. to delete this message at once.
(P5, 16)? Select [TV ASPECT] in the [SETUP]
You can only use 4 GB cards if they are menu to change the TV aspect. (P23)
SDHC Memory Cards. ? This message also appears when the
[MEMORY CARD ERROR USB connection cable is connected to
the camera only.
PLEASE CHECK THE CARD]In this case, connect the other end of
? Failed access to the card.the USB connection cable to a PC or a
Insert the card again.
printer. (P84, 87)
[READ ERROR
PLEASE CHECK THE CARD][PLEASE RE-CONNECT THE PRINTER.]
This message appears if you change the
Data reading error.mode dial to [] while the camera and
Insert the card again. Make sure the card is
inserted properly and then play back again.the PC are connected. Set the camera to a
mode other than [] mode, check that no
[WRITE ERROR data is being transferred and then connect
PLEASE CHECK THE CARD]to the printer again. ([ACCESS] appears
Data writing error.on the LCD monitor of the camera while
Turn the camera off and remove the card. data is being transferred.)
Then insert the card and turn the camera
[USB MODE CHANGED. PLEASE
on again. This error may also indicate that REMOVE THE USB CABLE.]
the card is damaged.This message appears if you change the
[MOTION RECORDING WAS CANCELLED mode dial to a mode other than [] while
DUE TO THE LIMITATION OF THE the camera and the printer are connected.
WRITING SPEED OF THE CARD]Set the mode dial to [] again and then
? When you set the [PICT.MODE] to disconnect the USB connection cable. If
[30fpsVGA] or [30fps16:9], we recommend this happens during printing, stop printing
using cards that offer 10 MB/second or and then disconnect the USB connection
higher speeds (shown on their packages cable.
and elsewhere) for best results.
97
VQT1C63 |
ACEC
