PANASONIC DMCLS80 Instruction Manual

Advanced-Shooting
Making the LCD monitor easier to ModeUses
see (LCD mode)Brightness of the LCD monitor
AUTO automatically changes
depending on brightness of
POWER LCD
the environment.
1Press and hold [Q.MENU] until The LCD monitor becomes
quick setting screen is displayed. POWER brighter and easier to see
LCD even when taking pictures
outdoors.
This is useful
HIGH when you cannot
ANGLE get close to the
subject because
there is a person
in the way.
(More difŢ cult to
see when looked
Q.MENUstraight on.)
2Select indication at the right end OFFThe LCD monitor returns to
(initial setting: [OFF]) using q, the normal brightness.
select mode using e/r and press
[MENU/SET].
? You can set LCD mode in setup menu.
( P21 )
? High angle mode is canceled if you
turn the camera off. (Same occurs in
[POWER SAVE].)
? The LCD monitor automatically returns to
normal brightness after 30 seconds when
SELECT EXIT
recording in power LCD mode. Press any
button to make the LCD monitor bright
again.
? The brightness of the pictures displayed
on the LCD monitor is adjusted when
power LCD mode or high angle mode
is activated. Therefore, some subjects
may look different on the LCD monitor.
However, this does not affect the
recorded pictures.
? If the screen is difŢ cult to see because of
light from the sun etc. shining on it, use
your hand or another object to block the
light.
? The number of recordable pictures
decreases when the auto power LCD,
power LCD or high angle mode is used.
38
VQT1L50
7725-@%.$-4@11$JOEE


25-@%. $-4@11$JOEE