Error messages
On the televisionPage
No disc.eYou haven?t inserted a disc. Correctly insert a disc that this unit can use. 11
eThe disc is upside down. If it is a single-sided disc, insert it so the label is facing up. 15
This is non-recordable disc.eThe unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R. 11
eYou inserted an unformatted DVD-RAM. Format the disc with this unit.34
This disc is not formatted
properly.
Please format the disc in
?DISC SETTING? to record.
This disc cannot be read.eYou inserted an incompatible disc.11
Please check write protect tab eThe write-protect tab on the cartridge is set to PROTECT.
on the disc.Use a ballpoint pen or similar to release the write protection.
?
PROTECT
Contents of this disc are pro-eThe program is write-protected. Cancel the protection.32
tected.eThe disc is write-protected. Cancel Disc Protection.34
Cannot finish recording com-eThe program was copy-guarded. ?
pletely.eNo space left on the disc.
Create space by erasing any unwanted programs. [RAM]32
Use a new disc. [RAM] [DVD-R]?
eRecording was not completed for some other reason.?
Cannot record on the disc.eThe disc is scratched. Use another disc.?
eThe disc is dirty.50
eYou inserted an incompatible disc.11
Disc is full.eNo space left on the disc.
Create space by erasing any unwanted programs. [RAM]32
Use a new disc. [RAM] [DVD-R]?
Please set clock.eThe clock is not set.49
This disc may not be played eYou tried to play a disc with a region number different from this unit?s region number. This unit
Cover
in your region.can only play discs with the region numbers compatible with this unit (1, All, or including the
page
number 1).
Your selection exceeds the eA ratings level has been set for DVD-Video with this unit. Unlock the unit with ?Ratings? in46
recorder?s rating limit.?Disc?.Reference
Finalizing is necessary for eTo enable playback of your DVD-R on compatible equipment, it is necessary to finalize it.34
compatible playback.
Error has occurred. Please eA serious, but temporary error has occurred and one of the unit?s safety devices has activated. ?
press [ENTER].Press [ENTER]. The unit switches to the standby mode. Press [? , DVD POWER] to turn the
unit on again.
On the unit?s display
NO READeThe disc is dirty or badly scratched.
? Clean the disc if it is dirty. 50
? The disc cannot be played if it is scratched and this display doesn?t disappear.?
eThe unit cannot read the disc.?
eYou have used a DVD-RAM/PD lens cleaner and it has finished.50
UNSUPPORTeYou have inserted a disc the unit cannot play or record on.11
U14eThe unit is hot.
? The unit switches to standby automatically for safety reasons and you cannot operate it.?
Wait for about 30 minutes for the service number to disappear.
? Select a position with good ventilation when installing the unit.?
? Do not block the cooling fan on the rear of the unit.?
U99eThe unit fails to operate properly. Press [? , DVD POWER] to switch the unit to standby. Now?
press [? , DVD POWER] again to turn the unit on.
CHK REMOTEeThe remote control and main unit are using different codes. Change the code on the remote45
control or main unit.
RECOVEReThere was a power failure or the AC plug was disconnected while the power was on. The unit?
is carrying out its recovery process. Wait until the message disappears.
51
RQT6920 |
ACEC
