7301en.book 20 k 237677627 1
Timer recording
Refer to the control reference on page 19.
6Press [?DVDPOWER].
You can enter up to 16 programs up to a month in advance. The unit turns off and ?F lights on the unit?s display to
(Each daily or weekly program is counted as one program.)indicate timer recording standby has been activated.
eWhen connecting a cable TV box or satellite receiver, select the [RAM]
channel on the cable TV box or satellite receiver before the timer eEven if the unit is in timer recording standby, you can play the disc.
recording starts.Without pressing [? DVD POWER], just press [1 ](PLAY) or
[DIRECT NAVIGATOR]. Timer recording works even during play.
Manually programming timer
recordings+ To release the unit from recording standby
Press [? DVD POWER].
1Press [PROG/CHECK].The unit turns on and ?F goes out.
Recording
eBe sure to press [? DVD POWER] to return the unit to standby
TIMER
Remaining Recording Time1:58 SPmode before the scheduled recording time. Timer recording will
RECORDING3/26 TUE 12:55 PM
No CHANNELDATEONOFFMODE CHECKwork only if F is displayed.
01 64 ABC 3/ 26 TUE 1:00 PM 2:00 PM SP OK
New Timer Program
+ To cancel recording when recording has
already begun
Press [+ ], then [ENTER] within 5 seconds.
eYou can also press and hold [+ ] on the main unit for more than
3 seconds to stop recording.
CANCELPress ENTER or VCR Plus+ to
store new program.
[Note]
e?F flashes when the unit cannot go to timer recording standby
2Press [3,4] to select ?New Timer
(e.g., a recordable disc is not in the disc tray).
eWhen you program successive timer recordings to start
Program? and press [ENTER].
immediately one after the other, the unit cannot record the part
3Press [1] to move through the items at the beginning of the later programs (a few seconds when
recording with DVD-RAM and approximately 30 seconds when
and change the items with [3 , 4 ].recording with DVD-R).
eIf you set DST (Daylight Saving Time) to ON when manually
TIMER
Remaining Recording Time1:58 SP
RECORDINGsetting the clock (! page 38), timer recording may not work
3/26 TUE 12:55 PM
when summer switches to winter and vice versa.
CHANNELDATEONOFFMODE
64 ABC 3/ 26 TUE 2:30 PM 3:00 PMSP
Enter Name
ePress and hold [3 , 4 ] to alter ON (Start time) and OFF
(Finish time) in 30-minute increments.
eYou can also set CHANNEL, DATE, ON (Start time), and
OFF (Finish time) with the numbered buttons.
eYou can also press [REC MODE] to change the recording
mode.
eDATE
[.Date:Current date up to one month later minus
lone day
;:
l
Daily timer:SUN-SAT> MON-SAT> MON-FRI
l
l;:
a.Weekly timer: WEEKLY SUN> ---> WEEKLY SAT
eEnter Name
Press [2 , 1 ] to select Enter Name and press [ENTER]
(! page 34).
4Press [ENTER].
TIMERTIMER
Remaining Recording Time1:58 SP
RECORDING
3/26 TUE12:55 PM
No CHANNELDATEONOFFMODE CHECK
01 64 ABC 3/ 26 TUE 1:00 PM 2:00 PM SP OK
02 64 ABC 3/ 26 TUE 2:30 PM 3:00 PM SP OKCheck to make
New Timer Program
sure OK is
displayed.
CANCEL
c
Repeat steps 24 to program other recordings.
5Press [PROG/CHECK].
The message TURN RECORDER OFF FOR TIMER
RQT7301RECORDING.? is shown on the television.
20 |
ACEC
