Troubleshooting Guide
General IssuesOperation
Page
Cannot operate the TV or Set � Change the manufacturer code on the remote control.68
Top Box with the units remote � Select TV or Set Top Box mode on the remote control.68
control.
Cannot operate the DVD. � Press [DRIVE SELECT] to select the DVD drive when operating 7
DVDs or CDs.
Make sure the TV is on the correct channel or input mode.
Cannot operate the VHS. � Press [DRIVE SELECT] to select the VHS drive when operating 7
VHS cassettes.
Make sure the TV is on the correct channel or input mode.
The remote control doesnt work. � The remote control code is wrong. Change to the correct code.78
� The batteries are depleted. Replace them with new ones.5
� Point the remote control at the remote control sensor on the main unit.5
� Remove obstacles between the remote control and main unit.
� Remove dust from the transmission window and the units sensor.
� Colored glass may obstruct the signal reception/transmission.
� Dont place the signal sensor in direct sunlight or in areas that may
be subject to sun exposure.
� It may be necessary to set the code on the remote control again 78
after changing the batteries.
� It may be necessary to set the manufacturer code again after 68
changing the batteries.
The unit is on but cannot be � Some operations are prohibited by the disc.
operated.
� The unit is warm (U59 appears on the units display). Wait until
U59 disappears.
� One of the units safety devices may have been activated.
Reset the unit as follows:
Press [? /I POWER] on the main unit to switch to off.
If the unit doesnt switch to off, reset the unit (Ľ 78, To restore the
unit if it freezes).
U88 is displayed and the disc � The unit is carrying out the recovery process. Do the following to
cannot be ejected.eject the disc:
(1) Press [? /I POWER] on the main unit to switch to off.
If the unit doesnt switch to off, reset the unit (Ľ 78, To restore
the unit if it freezes).
(2) While the unit is off, press and hold [� ] and [CH W ] on the main
unit at the same time for about 5 seconds. (Ejection may take
extra time depending on discs.) The disc may be defective. Try
another disc.
Cannot eject a disc. � The unit is recording.
� The unit may have a problem. Eject the disc as in (2) above.
Startup is slow. � Startup takes time in the following situations:
A disc other than a DVD-RAM is inserted.
The clock is not set.
Immediately after a power failure or the AC power supply cord is
connected.
When the unit is connected with an HDMI cable.
A password screen appears and � If the unit starts receiving a broadcast with the set rating information, 52
you are unable to view or record.a password screen appears and you will be unable to view or record.
Enter your password to continue.
Time is incorrect after using � Try again. If the time is still incorrect, set the clock manually.48, 66
Auto Clock Setting.
80
RQT8853
..JOECJOEC |
ACEC
