AG-DVC60E_En.fm 76 Mo+ 9�9�9a239a79Ţ6?776?
?29�79a9� 1
Before calling for service (cont.)
Playback (sound)
I can?t hear any sound ? Have you turned down the camera-recorder?s volume control too P44
from the camera-far?
recorder?s speaker.In the VCR mode, adjust the volume level using the multi dial.
I can hear two sets of ? Have you selected ?MIX? as the 32K (12bit) AUDIO item setting on P67
sound.the PLAYBACK FUNCTION screen?
? If you perform audio dubbing on a tape that was recorded with ?32K P69
(12bit)? selected as the AUDIO REC item setting on the RECORD-
ING SETUP screen, you will hear the sound heard during recording
and that of the audio dubbing.
When I performed audio ? If you perform audio dubbing on a tape that was recorded with ?48K P69
dubbing on an existing (16bit)? selected as the AUDIO REC item setting on the RECORD-
recording, the original ING SETUP screen, you will erase the original sound on the tape.
sound was erased.To leave the original sound intact, make sure that ?32K (12bit)? is
selected as the item setting when you shoot the original recording.
Other
I can?t remove the cas-? Is power still being supplied to the camera-recorder? (Is the power ---
sette tape.from the AC adapter and battery supplied properly?)
So long as the power is supplied, you can remove the cassette
even if the POWER lever is at the OFF position.
I can remove the cassette ? Has condensation formed? P77
but I can?t perform any If it forms, the only operation you can perform is to remove the cas-
other operations.sette. Wait until the condensation has dried out.
? If the cassette cover is closed immediately after sliding the EJECT ---
switch to open the cassette cover, you may no longer be able to
perform any operations other than eject. If you did this, slide the
EJECT switch again to open the cassette cover, check that the cas-
sette mechanism has finished ejecting the cassette, and then close
the cassette cover.
The remote control unit ? Has the button battery in the remote control unit run out? P19
does not work.If the remote control fails to work even when it is operated near the
camera-recorder?s remote control sensor, it means that the button
battery has run out. Replace it with a new one.
? Is the remote control setting the same for the remote control unit P19, 72
and the camera-recorder?
If the REMOTE item setting does not correspond between the two
units, the remote control unit will not work.
I hear a rattling sound ? There are some parts in the structure of the camera unit that make ---
when I tilt the camera-a rattling sound in the VCR mode or when the POWER lever is at
recorder back and forth.the OFF position. This is not a sign that something is broken.
76 (E) |
ACEC
