Dubbing
Analog input
Use the dubbing function to copy the contents of S-Analog/digital (AD) conversion
VHS (or VHS) cassettes onto DV cassettes or You can use this unit to convert analog to digital
record the television. signals. In the setup menus, AV IN/OUT SETUP
screen, set DV OUT to ?ON?. (Page 74)
This enables you to output digital images, which
1Connect this unit to a video deck or a were input as analog signals from an external unit,
television. (Page 54)through this unit?s DV connector to another digital
video unit.
2Press the CAMERA/VCR button and switch to
the VCR mode. Video deck, etc.
CAMERA
Analog signals
VCR
3Turn on the power of the external unit, and play
back the tape.
This camera-
4To start recording video signals from the recorder
connected devices, press two VCR REC
buttons at a time.
On the remote control, while pressing the REC
button, press the PLAY button.
VCR REC buttons
Digital signals
COUNTER RESET TITLEZOOMOther digital video
MULP-IN-PTI/REC A.DUB
? VOL +/REW PLAYFF/ unit
STILL ADV PAUSE STILL ADV
INDEXSTOP INDEX
? Normally, set DV OUT to ?OFF?. Images may be
disrupted if you set it to ?ON?.
Cameraor remote control? You can also use an S-video cable.
? Connecting external units (Page 52)
? If you press these two buttons during pause,
the unit will go to shooting standby mode.
Each time the [h] button of the OPERATION
lever is pressed, the unit switches between
shooting and the shooting standby mode.
5Move the OPERATION lever [g] to stop
recording.
6Stop playback on the external unit.
You cannot adjust the audio level.
E-57 |
ACEC
