EP790K230 ?y 18-19
MASSAGING HEADS RANGE MOVEMENTTROUBLESHOOTING GUIDE
The width between the massage heads can be adjusted for tapping, rolling, regional rolling, Before requesting service for this unit, check the table below for the possible cause of the
tapping rolling massage and regional tapping rolling massage.problem. Some simple checks or minor adjustment on your part may eliminate the
The heads can be set at different widths for a wide range, giving you a massage any place problem and restore proper operation. If you are in doubt about some of the check points,
you like from the neck to the lower back.or if the remedies indicated in the chart do not solve the problem, refer to the directory of
authorized servicenters (see the servicenter list included) to locate a convenient
servicenter, or consult your authorized Panasonic dealer for instructions.
<UPWARD, DOWNWARD MASSAGE>
Massage range width : 2 15/16 in. (75 mm) (width cannot be adjusted)
ProblemProbable cause(s)Suggested Remedy
Massage does not start.The power cord is not plugged Plug the power cord into an AC
Neckin.outlet (120 V).
The power source switch is at Slide the power switch to �on�.
2 15/16 in. (75 mm)
(Minimum width)the �off� position.
23 1/16 in. (600 mm)All lamps on controller flash and If the massage heads are Raise your back slightly and
massage heads Stop.forcibly locked, they will stop for push the start/reset button.
safety.
Lower backKneading massage cannot be The massage heads must move Wait until the massage heads
changed immediately to a rolling to the narrowest position for a reach the narrowest position.
massage.rolling massage.
<TAPPING, ROLLING, REGIONAL ROLLING, TAPPING ROLLING AND REGIONAL Massage heads do not reach Your shoulders are too high.Shift your waist forward and
TAPPING ROLLING>your shoulders.recline the chair back.
Massage range width : 3 5/16 in. or 4 5/16 in. (85 mm or 110 mm)
It seems like the massage heads This is because an alternating
are at different heights. tapping mechanism is used. It is
not a malfunction.
Neck
Alternating tapping mechanism
3 5/16 in. (85 mm)
Approx.
4 5/16 in (110 mm).23 1/16 in. (600 mm)13/32 in. (1 cm)
at most
Approx.
13/32 in. (1 cm)
Lower backat most
When stopped, the misalignment
is approx. 1 cm at most.
1819 |
ACEC
