shaving head is clogged with foam,Replacing the inner bladesSpecifications
simply rinse it under running water.(see fig. 6)Power source: 3.0 V DC
Press the foil frame release button
(Two OAA� alkaline batteries, not in-
and remove the foil frame. Removecluded)Cleaning your shaver
(see fig. 4)the inner blade one at a time by
For cleanliness and convenience, wegrasping it firmly at both ends andThis product is intended for house-
recommend that you clean yourpulling straight away from the shaver.
hold use only.
shaver with water and a liquid handTo insert the new inner blades, hold
soap. Regular cleaning will keep yourthe blade one at a time at both ends
shaver in good condition while pre-and press downward until it snaps
venting odors or bacteria from devel-into the shaver.
oping, and maintain the cutting per-
formance.Caution
With the outer foil in place, applyY The outer foil is very thin. If han-
some hand soap onto the outer foil.dled improperly, it can be easily
Turn the shaver on and pour somedamaged. To avoid personal injury,
water over the outer foil.do not use the shaver if it has a
After about 10-20 seconds, turn thedamaged foil or inner blade.
shaver off.Y Always check the outer foil and in-
Remove the foil frame and clean itner blades for damage before use.
with running water.Y Always replace protective cap af-
Wipe off any moisture from theter use.
shaver with a dry cloth and removeY Do not take the housing apart as
the protective cap to allow the outerthis can affect the watertight con-
foil to dry completely.struction.
Y If the shaver is not used for a long
Replacing shaving headtime, remove the batteries to pre-
componentsvent possible leakage.
Y Do not use new battery with old one
It is recommended that you replace
the outer foil at least every year andas the batteryOs life is reduced.
Y Close supervision is necessary
the inner blade at least every two
years to maintain your shaverOs cut-when this shaver is used by, on or
near children or invalids.
ting performance.
Y Never drop or insert any object into
Replacing the outer foilany opening.
(see fig. 5)Y Do not use outdoors or operate
Squeeze the outer foil release but-where aerosol (spray) products are
tons and lift the outer foil upward tobeing used or where oxygen is be-
remove it. To insert the new outer foil,ing administered.
press down until it snaps into place.FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN
USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE
AT 1-800-338-0552.
67
7 |
ACEC
