Parts identificationA full charge will supply enough
10
ed(see fig. 1)power for approx. 14 shaves (3 min-
utes per shave for a normal beard).
A Protective cap
B System outer foil(For ES8017/ES8018/ES8019, see
C System outer foil release buttonsfig. 2)
You should charge the shaver for 1
D Foil frame
hour if the battery capacity lamp
j
fE Inner bladesblinks red. The battery capacity lamp
a
F Foil frame release buttonswill glow in three colors depending
igon its charge capacity level:
G On/Off switch
100% - 30%: green
H-a Battery capacity lamp30% - 10%: orange
H-b Low battery indicatorless than 10%: blinking in red
h
I Charge (status) lamp
(For ES8016, see fig. 3)
bc
J TrimmerYou should charge the shaver for 1
K Trimmer handlehour if the low battery indicator glows.
L Power cordCord shaving
Connect the shaver to the AC outlet
READ ALL INSTRUCTIONS BE-
and turn the shaver on.
FORE USE.
If the shaver does not run, charge it
for approx. 1 minute.
Charging and cordless
shavingUsing your shaver
When charging the shaver for the first
Caution � The system outer foil is
time or when it has not been in use
very thin and can be damaged if
for more than 6 months, charge it for
handled improperly. Before each
at least 8 hours before use.
use, always check the foil for dam-
Connect the power cord to the
age. To avoid personal injury, do
shaver, and plug the power cord to
not use if the foil or other parts of
an AC outlet.
the shaving head is damaged.
It will adjust automatically to voltages
between 100-240V AC.Push the On/Off switch to turn the
In some areas, a special plug adap-shaver on. Hold the shaver at a right
tor may be required.angle (90°) to your skin (see fig. 4).
The charge (status) lamp will glowStart out shaving by applying gentle
when the shaver is being charged. Itpressure to your face. Stretch your
will flash when the charging is com-skin with your free hand and move
pleted.the shaver back and forth in the di-
67
7 |
ACEC
