1@&4@64"1.�?´
Caution � To prevent� Wash the shaver in tap water. DoSpecifications
WARNING for Lithium Battery:not use salt water or boiling water.
Fire, explosion, and severe burnpersonal injury or damagePower source: 100-240V AC,
hazard.Also, do not use cleaning products50-60 Hz (Automatic voltage conver-
to the product,that are designed for toilets, bath-
Do not crush, disassemble, heat� Do not charge the shaver where itrooms or kitchen appliances. Dosion)
above 100�C (212�F), or inciner-Motor voltage: 3.6 V DC
will be exposed to direct sunlightnot submerge the shaver for a long
ate.or a heat source, or where there istime.Charging time: 1 Hour
How to remove the built-ina lot of moisture.� Do not wipe any part of the shaverThis product is intended for house-
rechargeable battery before� Use only the included adaptorwith thinner, benzine or alcohol.hold use only.
disposal of the shaverRE7-27 to charge the ES8807Clean it by using a cloth dampened
(see fig. 10)shaver.with soapy water.
� Dry the shaver completely before� Do not take the housing apart as
WARNING:
Do not attempt to replace the bat-charging it.this can affect the watertight con-
� The shaver and adaptor will be-struction.
tery for the purpose of reusing thecome slightly hot during use or� Do not clean with water when the
shaver. This could result in the risk
of fire or electric shock.charging, however, this is not ashaver is connected to the power
malfunction.cord.
The battery in this shaver is not in-� Keep the adaptor away from water� When cleaning the shaver with
tended to be replaced by consum-and handle it only with dry hands.water, do so with both the inner
ers. However, the battery may be re-� Grip the adaptor when disconnect-blades attached. (Doing so with
placed at an authorized serviceing it from an AC outlet; tugging ononly one of the inner blades at-
center. The procedure described be-the power cord may damage it.tached makes an abnormal noise
low is intended only for removal of� Store the adaptor in a dry areaand may damage the shaver.)
the rechargeable battery for the pur-where it will be protected from dam-� Keep the unit away from children.
pose of proper disposal.age.� Keep instructions in a safe place.
1. Disconnect the power cord from� Do not pull, twist, or severely bend� The adaptor is intended to be cor-
the shaver when removing thethe power cord.rectly orientated in a vertical or floor
battery.� Do not wrap the power cord tightlymount position.
2. Remove the bottom cover screwaround the appliance.
(a).� If the power cord gets damaged, it
3. Remove the trimmer (b).alone can not be replaced.
4. Slide the back panel (c) and re-Contact an authorized service
move it.center.
5. Remove the side panel (d).� In cases where static noise is emit-
6. Remove the three housingted from the television during use
screws (e).or recharging, connect the adap-
7. Remove the housing (f).tor to a different outlet.
8. Lift the battery (g) and remove it.� Do not touch the edge (metal part)FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE
of the inner blade.(IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT
Failure to observe this may lead to1-800-338-0552.
hand injuries.FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES
MENTIONED ON THE BACK PAGE.
1011
1011 |
ACEC
