Installation (continued)
< Installation example > Adjustment pole preparation
Install adjustment pole A to adjustment pole B and to angle adjusting bracket B by following the procedure
BBInstalling to a concrete structure
#Insert commercially-available anchor nuts or below.
5
curled plugs (M8 or /16ý) into the attachment plate
mounting holes according to the method specified
Concrete
Procedure
by the manufacturer.
#Use the four accessory hexagonal head screws to secure angle
Anchor nut or
adjusting bracket B to adjustment pole B as shown in the5
curled plug$Place a size M8 or /16ý flat washer and spring
illustration at left.
5
(M8 or /16ý)washer onto each of the bolts that are supplied
Adjustment
NOTE:
with the anchor nuts or curled plugs, and thenpoleB
Flat washerB Provisionally tighten the screws at left and right.
install the attachment plate as shown in the
Attachment plate
Spring washerillustration at left.
NOTE:
Hexagonal head
BB Install the attachment plate so that the arrow
5
bolt (M8 or /16ý)
mark points in the direction of the screen.
Provisionally tighten the
screws at the left and
NOTE:right.
5
BB Use only size M8 or /16ý hexagonal head bolts, nuts, flat washers and spring washers.
BB All bolts and nuts should be securely tightened, and sufficient measures such as using Fully tighten the screws
Two nutsat the front and back.
two nuts or painting should be employed as necessary to prevent any loosening.
$Insert adjustment pole B into adjustment pole A, so that the
holes are aligned, and then use two of the accessory hexagonal
Adjustmenthead screws to secure them.
poleANOTE:
The longerB Adjustment poles A and B are both provided with holes
projection shouldwhich are spaced at 20-mm intervals.
Secure in
be at the front.
Secure the poles together so that the hole positions match the
two places.
height obtained from the dimensions given on page 4.
Angle
adjusting
bracketB
%To eliminate any play in the adjustment poles, insert four of the
accessory hexagonal head screws into the holes on the opposite
sides to the holes which were used in step $ and securely
tighten these screws.
Secure in
four places.
67 |
ACEC
