EY6405(EU).book 6 k 237677627
Read the Safety Instructions booklet II. ASSEMBLY
and the following before using.
Attaching or removing bit
I. ADDITIONAL Note: When attaching or removing a bit, be sure
SAFETY RULESto set the Forward/Reverse lever to its cen-
ter position (switch lock).
1) Be aware that this tool is always in an operat-
ing condition, since it does not have to beThis tool is equipped with a keyless drill chuck.
plugged into an electrical outlet.1) Attachment
Insert the bit and turn the lock collar clock-
2) When drilling or driving into walls, floors, etc.,wise (looking from the front) to tighten. (Fig.
?live? electrical wires may be encountered.2)
DO NOT TOUCH THE CHUCK OR ANY
FRONT METAL PARTS OF THE TOOL! Hold2) Removal
the tool only by the plastic handle to preventTurn the lock collar counterclockwise (looking
electric shock in case you drill or drive into afrom the front), then remove the bit. (Fig. 3)
?live? wire.
3) Storage
3) If the bit becomes jammed, immediately turnKeep the bit in bit holder when not in use.
the main switch off to prevent an overload,Remove the battery pack to expose the bit
which can damage the battery pack or motor.storage compartment inside the handle hous-
Use reverse motion to loosen jammed bits.ing.
Bits up to 50 mm (1-31/32 inch) long can be
4) Do NOT operate the Forward/Reverse leverstored here. (Fig. 4)
when the main switch is on. The battery will
discharge rapidly and damage to the unitNote: If excessive play occurs in the chuck,
may occur.secure the drill in place and 1 open the
chuck claws by turning the lock collar and
5) During charging, the charger may become2 tighten the screw (left-handed screw)
slightly warm. This is normal. Do NOT chargewith a screwdriver by turning it counter-
the battery for a long period.clockwise (viewed from the front). (Fig. 5)
6) Use only a dry, soft cloth to wipe the unit. Do
NOT use a damp cloth, thinner, benzine, orAttaching or removing battery pack
other volatile solvents for cleaning.1. To connect the battery pack:
Insert the battery pack. It snaps into place to
7) When storing or carrying the tool, set the Forward/indicate proper connection.
Reverse lever to the center position (switch lock).2. To remove the battery pack:
Press the two buttons on the sides of the bat-
8) Do not strain the tool by holding the speedtery pack. Slide the battery pack out of the tool
control trigger halfway (speed control mode)body.
so that the motor stops.
9) Do not operate the speed selector switch
(LOW-HIGH) while pulling on the speed con-
trol trigger. This can cause the rechargeable
battery to wear quickly or damage the inter-
nal mechanism of the motor.
10) Young children should be supervised to
ensure that they do not play with the appli-
ance.
? 6 ? |
ACEC
