14) Do not attempt to disassemble the
battery pack housing. IV. OPERATION
15) Do not store the tool and battery pack
CAUTION:
in locations where the temperature
Use of a concrete drill bit larger than
may reach or exceed 50°C (1°F)
(such as a metal tool shed, or a car the recommended size may cause
damage to the driver.
in the summer), which can lead to
deterioration of the storage battery.
Chuck
16) Do not charge battery pack when the
temperature is BELOW 0°C (3°F) NOTE: Grease for bit
or ABOVE 40°C (104°F). This is very Grease the oval indentation on
important in order to maintain optimal the bit with the supplied grease
condition of the battery pack.at least once a month.
17) Do not incinerate the battery pack. It
can explode in a fire.
18) Avoid dangerous environment. Do not
use charger in damp or wet locations.
19) The charger is designed to operate on 1. To insert the bit
standard household electrical power 1-1. Insert a bit into the mounting hole, and
only. Do not attempt to use it on any turn it slightly to locate an engaged
other voltage!position.
0) Do not abuse cord. Never carry charger
1-. At the engaged position, push the bit
by cord or yank it to disconnect from as far as it goes. Make sure that the
outlet. Keep cord away from heat, oil bit is fixed by pulling it.
and sharp edges.
SDS PLUS type
1) Charge the battery pack in a well shank
ventilated place, do not cover the
charger and battery pack with a cloth,
etc., while charging.
) Use of an attachment not recommended
may result in a risk of fire, electric
shock, or personal injury.
3) Do not short the battery pack. A battery 2. To remove the bit
short can cause a large current flow, -1. Depress the chuck cover and pull the bit.
over heating and create the risk of fire
or personal injury.
4) NOTE: If the supply cord of this
appliance is damaged, it must only be
replaced by a repair shop authorized
by the manufacturer, because special
purpose tools are required.
5) TO REDUCE THE RISK OF ELECTRIC
SHOCK, THIS APPLIANCE HAS A
Bit adapter
POLARIZED PLUG (ONE BLADE IS
WIDER THAN THE OTHER).Use a bit adapter (standard) and bit.
This plug will fit in a polarized outlet 1. Remove the bit adapter from
only one way. If the plug does not fit the bit adapter holder on the
fully in the outlet, reverse the plug. If main unit.
it still does not fit, contact a qualified . Pull the bit holder. ( )
electrician to install the proper outlet. 3. Insert the bit. ( )
Do not change the plug in any way.
4. Make sure the bit is inserted
firmly by pulling it lightly.
Bit
holder5. Insert the bit adapter into the
mounting hole and turn to
locate an engaged position.
- 6 -
EY6803(UL).indb 62006/05/29 11:49:08 |
ACEC
