Attachingorremovingbatterydrilling. The brake operates and the
chuck stops immediately when the
pack
trigger is released.
1. To connect the batter y pack: 4. After use, set the lever to its center
Insert the battery pack. It snaps pionstiot ion (switch lock).
place to indicate proper connection.
Reverse Rotation Switch Operation
2. To remove the battery pack:
1. For reverse rotation, set the lever to
Press the two buttons on the sides reverse. Check the directi-on of rota
of the battery pack. Slide -the bat
tion before use.
tery pack out of the tool body.
2. Depress the trigger switch slightly to
start the tool slowly.
.OPERATION 3. After use, set the lever to its center
position (switch lock).
SwitchOperation
1. The speed increases with the
amount of depression of the tClutcrigger.h TorqueSetting
When beginning work, depress the
Adjust the torque to one of -the 5 pos
trigger slightly to start the rotation
sible settings 3o,r 333 position to
slowly.
the job.
2. A feedback electronic controlleCAUTION:r is Test the setting before
used to give a strong torque even in actual operation.
low speed.
Set the scale at this line.
3. The brake operates when t-he trig
ger is released and the motor stops
immediately.
Note: When the brake operates, a
braking sound may be heard.
This is normal.
Forward/ReverseleverOperation
Reference for Adjusting Torque
Scale TorqueUse
Approx. 1.0 Nm For driving terminal
1
(Forward (), Switch lock, Rev)er)se ((10 kf-cm or 8.7 in-lbs.)screws
Approx. 1.5 Nm For driving machine
CAUTION: Do not operate Forward/2
(15 kf-cm or 13.0 in-lbs.)screws
Reverse lever until the
chuck comes to a com-Approx. 2.5 Nm For driving screws
3
plete stop. Shifting during (25 kf-cm or 21.7 in-lbs.)into soft materials
rotation of the chuck may Approx. 3.4 Nm
4
damage the tool.(35 kf-cm or 30.5 in-lbs.)For driving screws
Forward Rotation Switch OperationApprox. 4.4 Nm into hardwood
5
1. For forward rotation, set the lever (45to k f-cm or 39.0 in-lbs.)
forward.
For powerful driving and drilling
2. Depress the trigger switch slightly to
start the tool slowly.For drilling to mor-
Percussion
tar, brick, etc.
3. The speed increases with the
amount of depression of the trigger
for efficient tightening of screws and
- 7 - |
ACEC
