Bit-locking functionSpeedSelection
1. With the trigger switch not engaCgheodo se a low or high speed to suit
and a screwdriver bit locked in pthe use.lace,
The more the speed control trigger is
the tool can be used as a manual
screwdriver (up to 22.6 Nm, 230 pkulled, the higher the speed becomes.
f-cm, 199 in-lbs).No load speed Torque
There will be a little play in theLOW chuck80 - 550/min (rpm), Strong
but this is not a malfunction.
HIGH 300 - 2000/min (rpm)Weak
2. This feature is handy for tightening
screws that require more torque tCAUTION:han Check the speed selector
the maximum torque of the driver (po-switch before use.
sition on the clutch), for confir ming Use at low speed when
the tightness of a screw or to loosen strong force is needed dur-
an extremely tight screw.ing operation. (Using at
high speed while a strong
force is applied may cause
a motor breakdown.)
Do not operate the
speed selector switch
(LOW-HIGH) while p-ull
ing on the speed control
NOTE: When the brake operates, a trigger. This can cause
braking sound may be heard. the rechargeable battery
This sound indicates engagement to wear quickly o-r dam
of the bit lock.age the internal -mecha
CAUTION: To eliminate excessive nism of the motor.
temperature increase of the * See appendix for 3RECOM-
tool surface, do not operate MENDED SPEED SELEC-
the tool continuously using TION´.
two or more battery packs.
Tool needs cool off time For Appropriate use of Battery
before switching to another
pack
pack.
Do not close up vent Ni-MH Battery pack EY9251
holes on body sides of the
body during operation . Charge the Ni-MH battery fully before
Otherwise, the machine- funcstorage in order to ensure a longer ser-
tion is adverselye da ffteoc tvice life.
cause a failure
The ambient temperature rang-e is be
Do NOT strain the tool(motor).tween 0?C (32?F) and 40?C (104?F).
This may cause damage to If the battery pack is used when the
the unit.battery temperature is below 0?C
Use the machine in such
(32?F) the tool may fail to function
a way as to prevent the air
properly. In that case, cha-rge the bat
from the body vent holes
tery until charging is compl-eted for ap
from blowing directly onto
propriate functioning of the battery.
your skin. Otherwise, you
may get burnt. When operating with a Ni-MH battery
When operating with a pack, make sure the place is well-
Ni-MH battery pack, make ventilated.
sure the place is well-venti-
lated.Battery Pack Life
The rechargeable batteries have a
limited life. If operation time becomes
- 8 - |
ACEC
